Laserfiche WebLink
Page 2 of 4 <br />• Change ID "BPL" to "SW-BPL". Where possible, use <br />archived excess sample to perform analysis of any <br />parameters listed in Table 1 (attached) that were not <br />previously analyzed/reported. This includes everything in <br />Table 1 except dissolved & suspended uranium and <br />dissolved Radium 226. <br />• Change ID "FBRG" to "SW-FBRG" <br />• Change ID "ARH" to "SW-ARH" <br />• Change 1D "LLHG" to "SW-LLHG" <br />• Change ID "D001" to "SW-D001" <br />• Change ID "BOIS" to "SW-BDIS" <br />For samples collected June 29, 2010, please revise the following ID designation: <br />C10070041 (collect date 6-29-10): <br />• Change ID "BPL" to "SW-BPL" <br />For the more recent orders, please revise those order requests as follows: <br />C10070271 (collect date 7-7-10): <br />C10070528 (collect date 7-13-10): <br />• Change ID "BPC to "SW-BPI!' <br />• Change ID "DISCHARGE" to "Dl$-D003" For this sample, <br />add Potentially Dissolved Uranium and Total Uranium. I will <br />find out if the technician filtered this sample. He was <br />Instructed to acidify but not to filter, then to notify ELI of <br />the acidification date and request Potentially Dissolved <br />Uranium so the lab could subsequently filter at the lab <br />under proper PD timing protocols then do the U analysis. <br />Also, total Radium 226+228 should be added, plus we <br />should get both dissolved and total Radium 226. <br />• Change ID "AWD" to "SW-AWD". For this sample, to the <br />extent possible please perform all analyses shown in Table 1 <br />(attached). <br />• Change ID "A001" to "SW-A001". For this sample, analyze <br />for dissolved uranium only (delete requests for all other <br />parameters). Report dissolved uranium and field-measured <br />parameters (temp, pH, conductivity). <br />• Change ID "D001" to "SW-D001". For this sample, analyze <br />for dissolved uranium only (delete requests for all other <br />parameters). Report dissolved uranium and field-measured <br />parameters (temp, pH, conductivity). <br />• Change ID."SWBOIS" to "SW-BDIS", For this sample, <br />analyze for dissolved uranium only (delete requests for all <br />other parameters). Report dissolved uranium and field- <br />7/20/2010