2010-05-10_PERMIT FILE - M1987151

Home Browse Search

STATE OF COLORADO 0 0 0 6.3.1 Maps, except the index map, must conform to the following criteria: (a) show name of Applicant; (b) must be prepared and s pned by a registered land surveyor, professional engineer, or other qualified person; (c) give date prepared; (d) identify and outline the area which corresponds with the application; (e) with the exception of the map of the affected lands required in Section 34-32.5- 112(2)(d), C.R.S. 1984, as amended, shall be prepared at a scale that is appropriate to clearly show all elements that are required to be delineated by the Act and these Rules. The acceptable range of map scales shall not be larger than 1 inch = 50 feet nor smaller than 1 inch = 660 feet. Also, that a map scale, appropriate legend, map title, date and a north arrow shall be included. EXHIBIT A - Legal Description and Location Map The legal description must identify the affected land, specify affected areas and be adequate to field locate the property. Description shall be by (a) township, range, and section, to at least the nearest quarter-quarter section, and (b) location of the main entrance to the mine site reported as latitude and longitude, or the Universal Transverse Mercator (UTM) Grid as determined from a USGS topographic map. A metes and bounds survey description is acceptable in lieu of Township, Range, and Section. Where available, the street address or lot number(s) shall be given. This information may be available from the County Assessor's office or U.S. Geological Survey (USGS) maps. 0 (1) n ? 6.3.2 0 Note: 6.3.1 (1) (b) is not included in Exhibit A, but is included in application form. (OK) (2) The main entrance to the mine site shall be located based on a USGS Topographic map showing latitude and longitude or Universal Transverse Mercator (UTM). The operator will need to specify coordinates of latitude and longitude in degrees minutes and seconds or in decimal degrees to an accuracy of at least five (5) decimal places (e.g., latitude 37.12345 N, ton0tude 104.45678 W). For UTM, the operator will need to specify North American Datum (NAD) 1927, NAD 1983, or WGS 84, and the applicable zone, measured in meters. (3) A map showing information sufficient to determine the location"of the affected land on the ground and existing and proposed roads or access routes to be used in connection with the mining operation. Names of all immediately adiacent surface owners of record shall also be shown. The operation location map shall be a standard 1:24,000 scale U.S. Geological Survey map. The location of the proposed operation shall be shown and labeled with the mine site name. EXHIBIT B - Site Description (a) a description of the vegetation and soil characteristics in the area of the proposed operation. The local office of the Soil Conservation Service (SCS) may Page 2 of 10