Laserfiche WebLink
amecO <br />C. Extend geomembrane into the anchor trench as shown in the DRAWINGS. The geomembrane <br />shall be seamed along the entire distance of the anchor trench to the termination of the <br />geomembrane sheet. <br />3.04 PROTECTION <br />CONTRACTOR shall be responsible for the following: <br />A. Do not use equipment or tools, which damage the geomembrane by handling, trafficking, excessive <br />heat, leakage of hydrocarbons, or other means. <br />B. Ensure prepared surface underlying geomembrane has not deteriorated since previous acceptance, <br />and remains acceptable until acceptance by CC &V, as detailed in Section 3.02. <br />C. Keep geotextile elements immediately underlying the geomembrane clean and free of debris. <br />D. Do not permit personnel to smoke or wear damaging shoes while working on geomembrane. <br />E. Unroll panels in a manner, which prevents scratches or crimps in geomembrane and does not <br />damage supporting Soil Liner Fill. <br />F. Place panels in a manner that prevents wrinkles (especially differential wrinkles between adjacent <br />panels). <br />G. Prevent wind uplift and damage to geomembrane subgrade by providing temporary and permanent <br />40 loading and/or anchoring that will not damage geomembrane. <br />H. Minimize direct contact of equipment and personnel with geomembrane. <br />I. Protect geomembrane in areas where excessive traffic is expected with geotextiles, extra <br />geomembrane, or other materials acceptable to MANAGER, DESIGN ENGINEER, and <br />CERTIFYING ENGINEER. <br />3.05 FIELD PANEL DEPLOYMENT <br />A. CONTRACTOR shall install field panels at locations indicated on CONTRACTOR's layout <br />plan, as approved by MANAGER, DESIGN ENGINEER, and CERTIFYING ENGINEER. <br />B. CONTRACTOR shall replace damaged (i.e., torn, twisted, or crimped) field panels, or portions <br />thereof, at no cost to CC &V. CONTRACTOR shall repair less serious damage according to <br />Article 3.10 of this Section, at no cost to CC &V. CERTIFYING ENGINEER shall determine if <br />material is to be repaired or replaced. <br />C. CONTRACTOR shall remove damaged panels, portions of damaged panels, and other <br />geomembrane scrap. <br />D. CONTRACTOR shall not deploy more geomembrane field panels in one day than can be seamed <br />during the day of deployment. <br />E. Geomembrane deployment shall proceed between ambient temperatures of fourteen degrees (14° <br />49 F) Fahrenheit to one - hundred degrees (100 Fahrenheit. Geomembrane placement shall not be <br />Section 02776 Page 14 of 22 September 3, 2008 <br />Geomembrane Revision 1 <br />SAProjects \1125E CCV CQAV - Tech Specs \02776.0.doc <br />