2009-07-15_REVISION - M1980244 ‎(26)‎

• Permit No: M1980244
• IBM Index Class Name: REVISION
• Doc Date: 7/15/2009
• Doc Name: LOB Relocate- Appendix D- Tech Specs 1
• From: CC&V
• To: DRMS
• Type & Sequence: AM9
• Media Type: D
• Archive: No

amec?
• observe prepared subgrade prior to geosynthetic deployment;
¦ monitor and document geosynthetic material placement, trial seam testing, non-.destructive
testing, seaming and repair operations, and destructive testing;
¦ identify seam samples for CQA destructive testing;
¦ assure that testing equipment used, and tests performed are conducted according; to project
SPECIFICATIONS and industry standards;
¦ perform or observe, document, and report test results to MANAGER as required;
¦ report any deficiencies to MANAGER that are not corrected to the satisfaction of the CQA
Monitor, including design or project SPECIFICATION changes; and
¦ prepare a Construction Certification Report describing the construction, any deviations from
SPECIFICATIONS or, DRAWINGS and details, details of all field and laboratory details,
subgrade acceptance forms, test data, tests results (both laboratory and field), QC submittals,
geomembrane panel layout as-built prepared by the CQA Monitor, professional certification
that construction was completed in compliance with the DRAWINGS and
SPECIFICATIONS. The report will be signed and sealed by the CERTIFYING
ENGINEER registered in the State of Colorado.
2.06 GEOSYNTHETICS MANUFACTURER:
is The Geosynthetics Manufacturer, also referred to as the "MANUFACTURER", is responsible for
production of the geosynthetic components outlined in this plan. Each MANUFACTURER must verify
prior to construction that the MANUFACTURER can produce material that meets the requirements outlined
in project SPECIFICATIONS.
2.07 GEOSYNTHETICS INSTALLATION CONTRACTOR:
The Geosynthetics Installation Contractor, also referred to as the "CONTRACTOR" or "INSTALLER", is
responsible for installation of the geosynthetic components, as outlined in the project SPECIFICATIONS.
The INSTALLER must meet the requirements outlined in the project SPECIFICATIONS.
The INSTALLER will be responsible for storage, handling, deploying, temporary geomembrane
anchoring, seaming, repairs and non-destructive testing, in accordance with the project plans,
SPECIFICATIONS and the INSTALLER's internal quality control program. It is the INSTALLER's
responsibility to see that all submittals are received as outlined in the project SPECIFICATIONS.
2.08 EARTHWORKS CONTRACTOR:
The Earthworks Contractor, also referred to as "CONTRACTOR" is responsible for proper delivery and
placement of earthwork components as outlined in the project SPECIFICATIONS.
PART 3.0 LINES OF COMMUNICATION
The CQA Monitor shall be capable of direct communication with the MANAGER, DESIGN ENGINEER,
• CERTIFYING ENGINEER and CONTRACTOR at all times. Deficiencies that can be easily remedied,
Section 01400.2 Page 3 of 11 September 3, 2008
Geosynthetic COA Plan Revision 1
SAPro1ects\1125 CC&V Phase 5 VLF\I - Tech Specs\Arequa IFC Specs\01400.2 rl.doc