Laserfiche WebLink
when the slip surface extends past the bottom of the <br />soil region, but may also occur on a benched <br />slope model with two sets of Slope Limits. <br />-109 = Soiltype for slice base not <br />located. This error should occur very rarely, <br />if at all. It may occur if a very low number of <br />slices is combined with certain soil geometries, <br />such that the midpoint of a slice base is <br />actually outside the soil region,even though <br />the slip surface is wholly within the soil region. <br />-111 = safety factor equation did not converge <br />-1000 = No valid slip surfaces are generated <br />at a grid center. Unable to draw a surface. <br />List of All Coordinates <br />Search Grid <br />-336.309 787.225 <br />730.412 787.225 <br />730.412 1853.946 <br />-336.309 1853.946 <br />Material Boundary <br />160.897 125.000 <br />232.715 125.746 <br />334.279 160.778 <br />Material Boundary <br />308.468 172.179 <br />335.725 161.277 <br />351.417 155.000 <br />366.417 155.000 <br />391.417 145.000 <br />511.417 175.000 <br />530.727 175.000 <br />714.131 135.435 <br />857.760 125.000 <br />886.302 115.936 <br />1452.118 113.384 <br />Material Boundary <br />286.224 180.000 <br />334.279 160.778 <br />335.353 160.348 <br />351.224 154.000 <br />366.224 154.000 <br />391.345 143.951 <br />511.540 174.000 <br />530.620 174.000 <br />713.989 134.443 <br />857.570 124.011 <br />\? 886.145 114.937