Laserfiche WebLink
PART II <br />Page No. 17 <br />Permit No.: CO-0038024 <br />2. Representative Sampling <br />• Samples and measurements taken as required herein shall be representative of the volume and nature of the monitored <br />discharge. All samples shall be taken at the monitoring points specified in this permit and, unless otherwise specified, before <br />the effluent joins or is diluted by any other wastestream, body of water, or substance. Monitoring points shall not be changed <br />without notification to and approval by the Division. <br />If the permittee monitors at the point of discharge any pollutant limited by the permit more frequently than required by the <br />permit, using approved test procedures or as specified in the permit, the result of this monitoring shall be included in the <br />calculation and reporting of data to the Division. <br />3. Analytical and Sampling Methods for Monitoring <br />The permittee shall install, calibrate, use and maintain monitoring methods and equipment, including biological and indicated <br />pollutant monitoring methods. All sampling shall be performed by the permittee according to specified methods in 40 C.F.R. <br />Part 136; methods approved by EPA pursuant to 40 C.F.R. Part 136; or methods approved by the Division, in the absence of a <br />method specified in or approved pursuant to 40 C.F.R. part 136. The analytical method selected for a parameter shall be <br />the one that can measure the lowest detected limit for that parameter unless the permit limitation or stream standard <br />for those parameters not limited, is within the testing range of another approved method. When requested in writing, <br />the Division may approve an alternative analytical procedure or any significant modification to an approved procedure. <br />When the most sensitive analytical method which complies with this part, has a detection limit greater than or equal to the <br />permit limit, the permittee shall report "less than (the detectable limit)," as appropriate. Such reports shall not be considered <br />as violations of the permit limit. The present lowest method detection limits for specific parameters (which have limitations <br />that are, in some cases, less than or equal to the detection limit) are as follows: <br />Effluent Characteristic Method Detection Limits, ug/1 <br />• Iron 100 ug/1 <br />Selenium 10 ug/1 <br />These limits apply to the total recoverable or the potentially dissolved fraction of metals. <br />The procedure for determining settleable solids is contained in 40 CFR 434.64. The method detection limit for measuring <br />settleable solids under this part shall be 0.4 ml/1. <br />4. Records <br />The pernuttee shall establish and maintain records. Those records shall include the following: <br />a. The date, type, exact location, and time of sampling or measurements; <br />b. The individual(s) who performed the sampling or measurements; <br />c. The date(s) the analyses were performed; <br />d. The individual(s) who performed the analyses; <br />e. The analytical techniques or methods used; <br />f. The results of such analyses; and <br />g. Any other observations which may result in an impact on the quality or quantity of the discharge as indicated in 40 CFR <br />122.44 (i)(1)(iii). <br />The permittee shall retain for a minimum of three (3) years records of all monitoring information, including all original strip <br />chart recordings for continuous monitoring instrumentation, all calibration and maintenance records, copies of all reports <br />required by this permit and records of all data used to complete the application for this permit. This period of retention shall <br />be extended during the course of any unresolved litigation regarding the discharge of pollutants by the permittee or when <br />requested by the Division or EPA. <br />• <br />