Laserfiche WebLink
III. COMMENTS - COMPLIANCE <br /> Below are comments on the inspection. The comments Include discussion of observations made <br /> during the Inspection. Comments also describe any enforcement actions taken during the <br /> Inspection and the facts or evidence supporting the enforcement action. <br /> This was a complete bond release inspection conducted by Janet Binns of CDRMS for exploration permit X-1994-214- <br /> 00. Scott Cowman and Joe Shoemaker of BTU-Empire Corporation(BTLJ-EC)accompanied the inspection. The <br /> weather was warm and dry during the inspection. BTU-EC drilled 22 exploration holes in 1994 and 1995. BTU- <br /> Empire Corp. (BTU-EC)submitted a drill hole abandonment report to the Division on March 18. 2003, Eight drill <br /> holes were finished as water wells. These eight drillholes are: 94001,94002,94003,94005. 95001, 950W 95010 and <br /> 95012. <br /> The Division received BTU-EC's bond release application on August 14, 2008. The bond release inspection was <br /> conducted on August 27, 2008. Access to the holes was achieved via existing ranch roads and overland. The Division <br /> and TCC were able to locate and access 9 pad areas. Reclaimed drill pads were located using aerial photographs, maps <br /> and UPS coordinates. GPS coordinates generally got us to within 100 yards of the actual pad. <br /> DRMS collected GPS coordinates at the hole locations or at the approximate center of the pad if no evidence of the <br /> hole was apparent. DBMS GPS is a Trimble GeoXT,coordinate system: NAD27. UTM, units=feet. <br /> This was a bond release inspection conducted by Janet Binns of Colorado Division of Reclamation. Mining <br /> and Safety. Joe Shoemaker and Scott Cowman of BTU-EC accompanied the inspection. The weather was <br /> cool and windy, and the area was dry. <br /> Roads: All access roads constmcted to the drill sites were reclaimed. Several of the drill locations were <br /> accessible by existing roads so access roads were not constructed to all the drill holes. <br /> 9400 L This drill hole had been finished as a 2" diameter well. There <br /> was no cap on the casing. The location is at the edge of a hayfield. <br /> The ad was ve etated and looked similar to the surrounding hayfield. <br /> 94001 <br /> 94001 <br /> 94001 A: This site was not located. <br />