Laserfiche WebLink
ARCADIS <br />I <br />Mr. Steve O'Brien <br />14 May 2008 <br />This analysis is for a straight slope from the toe of the slope to the structure or point <br />which is conservative for the concrete ditch and slurry wall since the slope would <br />have to slough to that angle from the proposed cut slope of 2:1. As shown, the factors <br />of safety are all well above 1.0 indicating the slopes will be stable. For the proposed <br />excavation limit a factor of safety of 1.35 is considered appropriate for the temporary <br />slope condition. The factors of safety for the concrete ditch and slurry wall are above <br />1.5 which is considered an acceptable threshold value for long-term structures. <br />These factors of safety would be less if the pit is dewatered, an adverse phreatic <br />surface is allowed to develop or if significant wave action erodes the 2:1 slope. It is <br />recommended that the pit slope be monitored and maintained at 2:1. <br />To evaluate a more adverse condition of a fully saturated slope with the pit fully <br />dewatered. The circular failure charts from Rock Slopes: Design, Excavation, <br />Stabilization, Publication No. FHWA-TS-89-045, Pages 9.5-9.13, September, 1989 <br />were used. Results from this analysis are the following: <br /> Calculated Factor of Safety for <br />Slope Evaluated Slope Angle Saturated Circular Slope <br /> Failure, 4) = 34 <br />Slope at Excavation Limit approx. 190 1.00 <br />Slope Toe to Conc. Ditch ISOM 1.34 <br />Slope Toe to Slurry Wall 7.1250(2) 2.233 <br />"1150 angle is calculated from 15 feet slope height and 55 feet horizontal measurement from <br />toe to ditch edge <br />(2)7.125° angle is calculated from 15 feet slope height and 120 feet horizontal measurement <br />from toe to shiny wall <br />This analysis is also for a straight slope from the toe of the slope to the structure or <br />point which is conservative for the concrete ditch and slurry wall since the slope <br />would have to slough to that angle from the proposed cut slope of 2:1. Although the <br />factors of safety are lower than the infinite slope evaluation, the analysis shows that <br />Page: <br />a wmar?aroranebw :A07ANA= 2/3