1987-12-01_PERMIT FILE - C1981017 ‎(297)‎

• Permit No: C1981017
• IBM Index Class Name: PERMIT FILE
• Doc Date: 12/1/1987
• Doc Name: Thermal Dryer Emission Permit
• Section_Exhibit Name: Chapter IV Appendix IV-A-2
• Media Type: D
• Archive: No

PART III
Page -12A of 13
PERMIT NO: CO-0000396
A. SPECIAL REQUIREMENTS - ACTIVITY PERMIT
1 . The permittee shall submit a written request 90 days prior to discharge
to the Colorado Water Quality Control Division and the U.S. Environmental
Protection Agency for any change in discharge points. The request shall
be accompanied by area maps which shall meet the specifications set
forth below. Each discharge point shall be numbered consecutively
(001 , 002, 003, etc. ) and designated on the map. The Division shall
approve or deny proposed discharge points in writing, or may in its
discretion require that the permittee accept different effluent
limitations as a condition of approval or submit a new permit application.
Approval of additional discharge points shall not consist of permit
modification, and no public notice or hearing will be required.
2. The permittee shall submit a written request to the Colorado Water
Quality Control Division and the U.S. Environmental Protection Agency
to deactivate a discharge point. The Division will grant or deny the
request. in writing. If the request is granted, monitoring and reporting will
not be required for such points. Any discharge from deactivated points
shall be considered a violation of the permit.
3. Area maps shall be made from USGS topographical maps (7.5 or 15-minute
series) or other appropriate sources as approved by the Colorado Water
• Quality Control Division. Each revised area map shall be 81 inches by
11 inches and reproducible by rapid printing methods or as approved by
the Division. Where additional 81-inch by 11-inch maps are required
to show the area of operation, they shall be numbered and a key shall be
shown on the first map. The first map section shall have the company
name, mine/job name, address, and NPDES number clearly printed thereon.
Also, one line of latitude and one line of longitude shall be marked on each
map section. The area map(s) shall delineate the following , using the
graphics as indicated:
(a) Existing Area of Operation (Solid Outline)
(b) Existing point source (Solid Triangle)
(c) The projected area of operation for
the 5-year life of an NPDES permit ------------ (Dashed Outline)
(d) Projected point source for the 5-year \
life of an NPDES permit (Opened .Triangle)
Amended
12