2008-03-24_GENERAL DOCUMENTS - M2003016 (2)

Home Browse Search

APPENDJX A -SWMP (cont.) Page B-3 The SWMP Administrator becomes the contact for all SWMP-related issues and is the person responsible for its accuracy, completeness, and implementation. Therefore, the SWMP Administrator should be a person in an authoritative position. Larger facilities may want to develop a "SWIvIP team" in order to share the responsibilitiesand generate greater awareness and participation. b) Materials Handling and Sni[l Prevention -Where materials can impact stormwater runoff, BMPs that reduce the potential for contamination shall be described For example, materials should be stored and handled in covered areas whenever possible to prevent contact with stormwater; fuels and other chemicals should be stored within berms or secondary containment devices to prevent leaks and spills from enteringstormwaterruroff. When selecting BIVIPs, the most important ones to evaluate first are those which limit the source of the pollutant. It is much more efficient, from both a cost and environmental standpoint, to prevent the pollution in the first place than to clean up contaminated stormwater. For example, a BMP requiring that any vehicle maintenance that involves fluid exchange must take place indoors, results in the removal of a pollutant source (i.e., oil/hydraulic fluids) from possible contact with stormwater. Good housekeeping measures, such as cleaning and maintenance schedules, trash disposal and collection practices, grounds maintenance, etc., can be included here. c) Erosion and Sediment Controls -Describe BMPs that will be used to reduce erosion and prevent sediment delivery to State waters. These should include structural (such as si/t fences, sediment ponds, drop structures, check dams) and non- structural (such as mulching and revegetation) methods. B1bIPs can describe a wide range of management procedures, schedules of activities, prohibitions or practices and other management practices. BIvIPs can include operating procedures, Treatment requirements and practices to control plant site ninoff, drainage from raw materials storage, spills or leaks. Nonshvctural BI41Ps are mainly definitions of operational or managerial techniques. Structural BMPs include physical processes ranging from diversion structures to oil/water separator; to retention ponds. The B1~IPs selected are up to the judgment of the individual pemrittee. However, it is important to note that a fully implemented SWMP will constitute compliance with Best Available Technology (BAT) and Best Conventional Technology (BCT), as mandated under the Federal Clean Water Act. This means that, in order to comply with your permit, the appropriate measures must be taken in keeping with the pollutant(s) involved and the risk potential at the facility. d) Identircation of Discharges other than stormwater -The stormwater conveyance system on the site shall be evaluated for the presence ojdischarges other than stormwater, such as mine drainage, spoil springs, sanitary waste, or process water of any kind. The SWMP shall include a description of the results of any evaluation for the presence of discharges other than stormwater, the method used, the date ojthe evaluation, and the on-site drainage points that were directly observed during the evaluation. A number ojdrscharges other than stormwater may not require a CDPS Industrial Wastewater Discharge permit and are considered Allowable Non-stormwater Discharges Flows from fire fighting activities, landscaping irrigation return Jlow or springs (except spoil springs) that are combined with stormwater discharges associated with industrial activity must be identified in the SWMP. In other words, only stormwater can be conveyed by the stormwater drainage system. Examples of potential illicit connections include floor drains and toilets in maintenance buildings, chemical storage buildings, etc. There are several methods of detemrining whether or not illicit connections exist. Acceptable procedures include dry weather observations of outfalls or other appropriate locations, analysis and validation of accurate piping schematics, dye tests, etc. Note - if illicit connections are discovered, corrective measures must be taken.