Laserfiche WebLink
sampling technique for each well is detailed below. These procedures were followed up to <br />the s <br />rin <br />of 1986 <br />New sam <br />lin <br />e <br />ui <br />t ha <br />been <br />r <br />ha <br />or <br />d i <br />d <br />d i <br />t <br />t <br />th <br /> p <br />g <br />. p <br />g <br />q <br />pmen <br />pu <br />n <br />s <br />c <br />se <br />an <br />ncorp <br />a <br />e <br />o <br />e <br /> fall 1986 sampling. This data will be reported in the 1987 AHR. <br /> Well No. Sampling Procedure and Remarks <br /> GW-S5: Shop well. Run bath house tap 20 min and sample. <br /> GW-S6A: Bail one casing volume (CV) and sample (low <br /> recovery alluvial well). <br /> GW-57: Static water level (SWL) = 70 ft. Cannot <br /> practically hand bail one CV out. Thus, bail 2 <br /> gallons off top (to remove oxygen-saturated water <br /> at the top of the Hell), sink bail to screened <br /> interval and remove sample. <br /> CW-58: One CV = 63 gal. SWL = 142 ft. 3" casing. Same <br /> sampling procedure used as for well CW-S7. <br /> CW-Sit: Flowing artesian well. Remove pressure gaugel <br /> allow wall to flow and sample. <br />C• GW-517: Pump two CVs with 4" pump and sample. <br /> GW-521: Flowing artesian well. Same procedure as for well <br /> GW-511. <br /> GW-525: Bail one CV; let recover approximately 1 hour and <br /> sample (low recovery well). <br /> GW-526: Bail one CV and sample. <br /> GW-527: Bail one CV and sample. <br /> GW-532: Bail one CV and sample (low recovery alluvial <br /> well). <br /> GW-533: Bail two CV and sample. <br /> GW-536WC: Bail one CV, let recover one hour and sample (low <br /> recovery well). <br /> GW-536-0: Same procedure as for well GW-S36-WC. <br /> GW-542P1: Same procedure as for well CW-S36-WC. <br /> GW-546: Bail out two CVs and sample. <br /> GS-531-A2: Same procedure as for well CW-532. <br />~• <br /> 17 <br />