REP08072 - Laserfiche WebLink

Home Browse Search

INSPECTION OF EXCESS SPOIL FILL Fout4hQuarter2002Certification RECEIVE® Fill Area No. 9 Date: December 26. 2002 ~A~ ~ II 203 GENERAL DESCRIPTION OR REFERENCE TO SITE PLAN: Division of Minerals and Geale®y The CTL Thompson report dated April 27, 2001, "Stability Analysis and Geotechnical Recommendations Lorencito Surface Mine Phase I" addresses the general requirements as also cited in Sections 4.09.1 to 4.09.2 of the Colorado Mined Land Reclamation Board for Coal Mining. ACTIVITY DURING INSPECTION: Removal of Topsoil and Organic Matter Placement of Underdrains Installation of Surface Drainage System Construction of Fill Placement of Topsoil _Seeding X Other Mine idle - No activity during this quarter SEDIMENT CONTROL Sediment pond constructimt has been completed in accordance with plans submitted to and approved by the DMG and as-constructed survey/drawings certified by Registered Land Surveyor and Registered Professional Engineer. All surface run-off from the fill areas is directed to this sediment control facility. No evidence of significant erosion was observed. SITE PREPARATION As indicated by previous inspection reports, organic materials such as brush and trees were removed from the proposed fill area followed by topsoil removal prior to fill placement. Design criteria did not require keyway cuts for steeper valleys with minimal soil cover (fill #9). DRAINAGE SYSTEM (UNDERDRAINS) Drain sizes are specified by CDMG regulations for fills which can be classified as Valley Fills. Fill area #9 is not a valley fill. CTL Thompson recommended a minimum 6' x 12' triangular section(area = 64 SF) for this size fill. As indicated by previous inspection reports, as constructed drainages generally were more trapezoidal with a top width of 12', bottom width of 8', and average height of 8' (area = 80 SF). Sandstone recovered from durable "channel" sandstone deposits encountered during the mining process were used in drain construction. Mirafi 160 fabric was used in lieu of filter material. FILL PLACEMENT CDMG regulations require that spoil be "placed in horizontal lifts in a controlled manner, concurrently compacted as necessary to ensure mass stability". Maximum lift thicknesses are not specified. As indicated by previous inspection reports, lifts were placed in accordance with plans specified by the CTL Thompson report. Spoil material was transported to the fill area using a combination of trucks and dozers. Left thicknesses of up to 50 feet were placed within the area removed from the fill face by more than 50 feet. Fill placement terminated by second quarter 2002.