PERMFILE117376

• Permit No: C1992081
• IBM Index Class Name: Permit File
• Doc Date: 6/19/2006
• Doc Name: Chemical Labels
• Section_Exhibit Name: Tab 20 Attachment 20-1B
• Media Type: D
• Archive: No

A
-. .. ,..-........,,uvvn.,vnr 4
severe infesmtions or when the height of the weeds varies so that no[ all weeds apply a 20 to 40 percent solution of [his product at a flow rate of 2 fluid ounces
a2 contacted, In tltesc instances, repeat treatment may be accessary, per minute and a walking speed of 0.75 miles per hour (2 [0 4 quarts per acre),
Recirrulafing Spray System Controlled droplet application equipment producesas m
A recirculating spiny system directs the spray solution onto weeds growing above visible. Extreme care must be exercised to avoid spray orndnR ccontaeting the
desirable vegetation, while spiny solution not intercepted by weeds is toll ccmd foliage or any other green tissue of desirable vegemtioq, es damage or destmction
and reurmed m the spray tank for reuse. may result.
Shielded sad Hooded Applicators 8.0 ANNUAL AND PERENNIAL CROPS
When applied under the conditions described k the following paragraphs for (Alphabetical)
shielded and hooded applications, this product at recommended rams will control _
those weeds listed in the " NOTE: THIS SECTION GNES GENERAL DIRECTIONS THAT APPLY 70
NIAL WEEDS RATE TAB1~E" seclions ofthis~labe7T ABhooded d • PEREN- BEI,(7W. SEE CTHEPIND[VIDUALE CRIOP CATEGORIES FOR SPECIE CLAI-
tYpcAfshielded applicator where the spray panem is fully rnclosed incl d~ng top, STRUCTIONS, PREHARVEST INTERVALS, AND ADDITIONAL pRECAU-
srdes, front and back, thereby shielding the crop from the spiny solution. Keep T10NS AND RESTRICTIONS.
shields on these sprayers adjusted to promo desirable vegemton. When applying See the "ROUNDUP READY CROPS" section of this label or sepammly pub-
to amps grown on mired beds, ensure that the hood is designed to completely en- ]fished Supplemenml Labeling for instructions for heating Roundup Ready crops.
close the"spray solution, If necessary, extend the front and rear flaps of the hoods
to reach the ground m deep furrows. EXTREME CARE MUST BE ERERCISED ~~ OF APPLICAT]ONS: Chemical Fallow, Preplant Fallow Beds, Pre ]ant,
TO AVOID COLJTACT OF HERBICIDE WITH DESIRABLE VEGETATION. Preemergencq At-Planting, Hooded Sprayers in Row-Middles, Shielded Sprayers
This equipment muse be set up and operated in a manner [ha[ avoids bouncing mentsw Middles, Wiper Applications in Row•Middles, and Post-Harvest 7rtat-
or raising the hoods off the ground in any way. It the hoods are raised, spray pq~R,gL USE INSTRUCTIONS:
panicles may escape and come into contact with the crop, causing damage or
destruction of [he crop. Avoid operation on rough or sloping ground whew the ~'PPIy this product during fallow intervals preceding planting, prior to planting or
spray hoods might be mired off the ground. transplanting, at-planting, or preemergent to annual and perennial crops listed in
Use hoods designed to minimize excessive dripping or rvn-off down the insides this label, except where apecificaDy 7imimd, For any crop II4l listed in this label,
of the hoods, A single, low pressure/low drift flat-fan nozzle with an 80 to 95
applications must be made at least 30 days prior to planting, Unlus otherwise
degree spiny angle posiROned at the top ccntcrofthc hood is recommended. Spiny ~eclfied' weed control applications may be made according m the rotes listed N
volume should be 20 m 30 gallons per aae. ANNUM. WEEDS", `'PERENNIAL
These procedures will reduce the potential for cro m AND TREES RATE TABLES" in this label Repeat applicationOs may be made
• The spiny hoods must tx opcmmd on the p J~S'~ up to a maximum of 8 quarts per acre per year.
• Leave at least an $-' ground or skimming across the ground. Post-directed hooded sprayers and wiper equipment capable of preventing nU
inch unheamd stop over the drill row. For example, if the cropp contact with hePoicide solutons may be used in mulched or unmukhed row
crop row wid[b is 38 inches, the maxrmum width of the spiny hood should be middles aRer crop esmblishment. Where specifica0y noted below, wipers may
30 inches, also be used above amain crops to control tall weeds. Refer to the °$elective
• Maximum tractor speed: 5 miles per hour to avoid bouncing of the spiny hoods. Equipment" section of dris label for essential precautions when using hooded
• Maximum wind speed: 10 miles perhour. sprayers or wipers to avoid cro m'u caused by leakage of s m mists or
• Usc low-drift nozzles that provide uniform coverage within the trcamd area dripping onto crops. Cro m" p ~ T P Y
Crop injury may occurwhrn the foliage of treated weeds comes into direct conmct p lint rs possrblc with these applicaions and sha0 be
the sole responsibility of [he applicator.
with leaves of the crop. Do not apply this product when the leaves of the crop ~0 maxunum use rotes stated throughout this product's labelin a
ere growing in direct contact with weeds to be ueated. Droplets, mist, foam or 6 pply to this
aplatmr of the herbicide solution may conmct the crop and cause discolamtion, product combined with thgred~en awhetmhe~ a pled eascmix rturts ore oaratel r
sulfosatc as the active in
smndng or destmetion. Calculam the application rams and ensure that the tom] use of this and nth r _
Wiper Applicators glyphosam or sulfosatc conmining products does not exceed smted maximum use
When applied under the conditions desenbed in the followi rate.
product CONTROLS many weeds, including volunteer corn, 7e arm anicum~ GENERAJ- pRECgL1TJONS, RESTRICTIONS: Avoid conmct of herbicide with
common rye, shaveroane, arckkpod, apanishneedks and brisNy starbur; wtd $UP_ folrag°' green shoots or stems, bark, exposed roots (including those emerging from
PRESSES many weeds including Florida beggarwced, Bertnudagmss, hem do - Plastic mulch), or fmit of crops because severe injury or destrmetion may result.
bane, dogfennel, guineagmss,johnsongrass,inilkweed, silverleaf ni hmhade, red- H7ten making prcemergence and at-planting applications, a hcations must be
root pigweed, giant ragweed, smutgmss, sunflower, Canada thisdeg made before crop emergence to avoid severe cro in u PP
vaseygrass, velvetleaf. musk dtistle, made at emergence wi0 result in injury or death to emerged dseedlings,r Apply
Wiper applicators are devices that physically wipe appropriate amounts of this Unlrsssothegrwise spec fed in this pr~uct~s tabelingmtreatm ors with sclecti e
product directly coin the weed. equipment including wipers and hooded sprayers must be made at leas[ J 4 days
Equipment must be designed, maintained and operated to prevent dtc herbicide Prior to harvest. post-harvest or fagow applications must be made at least 30
solution Cram conmcting desirable vegemtion. Operate this equipment et ground dANDPTECHN lanting any non-labeled crop, Sec "APPLICATION EQIJ[PMEN'f
speedsno greamrthan5 miles per hour.Performance may be improvedby reducing QUES"section of this label for additional information,
speed in areas of heavy weed infesmtions to ensure adequate wiper saturation. In crops where spot treahnenm arc allowed, do not treat more than 10 percent
Better results may be obtained if two applications are made in opposne dhecdons. of the coral field to be harvested, The crap receiving spray N heamd area will
Avoid leakage or dripping onto daimble vegemtion. Adjust height of applicator be killed. Take care to avoid drift or spiny outside [he mrget area for the same
to ensure adequate conmct with weeds. Keep wiping surfaces clean, Be aware reason.
that, on sloping ground, the herbicide solution may migmm, causing dripping on For broadcast postemergent hea[menm, do not harvest or feed treated vegemtion
the lower end and drying of the wicks an dte upper end of a wiper applicator. for 8 weeks following application, unless otherwise specified.
Do no[ use wiper equipment when weeds arc wet.
Mix only the amount of solution to be used Burin a 1-tm 8.1 Cereal and Grain Crops
activity may result from use of IeRover solutions. Clean wiperppans itnmediateld LABEI'ED CROPS: Barley, Buckwheat, Millet (pearl, proso), Oam, Rice, Rye,
after using this product by thoroughly Rushing with water, Y Qumoa, Taff, Teosinte, Triticale, Wheat (aII types), Wild Rice.
Do not add suttacmn[ to the herbicide solution. PRECAUTIONS, RESTRICTIONS: Do not rcpt rice fields or levees when field
Far Rope or Sponge Wick Applicators-Solutions ranging from 33 to 75 ement contains wamr.
of this product in water may 6e used. q P TYPES OF APPLICATIONS: Those listed in Section 8.0 plus the fo0owing: Red
section. PPh' this Solution to weeds lismd in this Rice Conhol Prior m Planting Rice, Spot Treatment (except Rice), peer-the-Top
For Panel Applicators-Solutions ranging from 33 to 100 percent of this product Wheat only)camrs (Feed Barley and Wheat only), Preharyest (Feed Barlry and
in water may be used in panel wiper applicataq.
7.5 lnjec6oo Systems Prep)any Preemergeneq AaPlanting
This product may be used in aerial or ground injection s ra USE INSTRUCTION: This product may be applied before, during or after
used as a liquid conecntrate or diluted riot to in actin P Y systpe ~. It may be planting of cereal Drops. Applications must be made prior to emergence of the
not mix this product with the concentrate of other products when using injection crop.
sysmms. Red Rke ConRO1 Prior to Planting Rice
7.6 CDA Equipment USE INSTRUC170N5: Apply 1.5 quarts of this product in 5 to 10 gallons of
The rate of this product applied per acre by vehicle-mounted CDA equipment ands nd of red nce.h Make apphcaton when the majority of the~red rice plan n
moat not be less than the amount recommendW in this label when applied by are N the 2-leaf singe and no mom than 4 inches mII. Acd rice plants with leh
convrntianal broadcast equipment. For vehicle-mounmd CDA equipment, apply than 2 We ]eaves ma be on1
2 to ]5 gallons of water per acre. Y y partially controlled.
For the control of annual weeds with hand-held CDA Units, a p PRECAUTIONS, RESTRICTIONS: Avoid spraying during low humidity condi-
solution of this product at a Row rate of 211uid ounces per minuet and a walking fields contain floodwamrm L)o notl repo not treat rice fields or levees when the
speed of 1.5 miles per hotu (1 quaff per acre), For the control of perennial weeds, applicalion. Rood treamd fields far $ days following
'Database and format copyright ©bv VPC Acquisition Corporanon..41 rights reserved.