Laserfiche WebLink
..Kvaerner Meta ! Project No. 306900 <br />Generdt Specmcation No. GC-18 <br />Geosvnthetic Liner <br />1.0 SCOPE <br />This specification covers the regwrements for furnishing materials. equipment. <br />transportation, labor and services necessary and inctdentaf to install geosynthettc ttner <br />for evaporation ponds. as indicated on the drawings and as specified herein for the <br />American Soda. L.L.P., Yankee Gulch Sodium Minerals Protect to be located ai two sites <br />about 45 miles apart in the State of Colorado. The one called Upper Plant is to be <br />located near Meeker in Rio Blanco County, and the other one called Lower Plant, to an <br />existing UNOCAL facility near Parachute to Garfield County. <br />2.0 APPLICABLE CODES AND STANDARDS <br />Except as noted within this specification, all lining work shall conform to the latest <br />revision of the documents listed below. These documents are declared to be a part of <br />this specification the same as tf fully set forth herein. <br />2.1 General <br />All Federal. State. County and Local regulations where they apply. <br />2.2 American Society for Testing and Materials (ASTM) <br />D 570 Standard Test Method for Water Absorption of Plastics <br />D 638 Standard Test Method for Tensile Properties of Plasttcs <br />D 746 Standard Test Method for Brittleness Temperature of Plasttcs and <br />Elastomers by Impact <br />D 751 Stanaard Test Method for Coated Fabrics <br />D 792 Standard Test Method for Specific Gravity and Density of Plasbc <br />by Displacement <br />D 882 Standard Test Method for Tensile Properties of thin Plastic <br />Sheeting <br />D 1004 Standard Test Method for Initial Tear Resistance of Film and <br />Sheeung <br />D 1203 Standard Test Method for Volatile Lass from Plasttcs Using <br />Activated Carbon Methods <br />D 1204 Standard Test Method far Linear Dimensional Changes of <br />Nonrigid Thermoplastic Sheeung or Film at Elevated Temperature <br />D 1238 Standard Test Method for Flow Rates of Thermoplastics by <br />Extrusion Plastometer <br />~ mewt,,wr~cvrnueneetesre ooc. Nw iii 3 0~....w,o,. u. tt~ <br />