2004-10-18_REVISION - M1980244 ‎(24)‎

• Permit No: M1980244
• IBM Index Class Name: Revision
• Doc Date: 10/18/2004
• Doc Name: Ph.IVc VOL.II Tech Specs
• From: Golder Associates Inc.
• To: DMG
• Type & Sequence: AM8
• Media Type: D
• Archive: No

SECTION 02776.0 GEOMEMBRANE
PART 1: GENERAL
• 1.01 SUMMARY:
This SPECIFICATION describes requirements for the manufacture, fabricafion (if needed), supply, and
installation of polyethylene geomembrane for lining of the valley leach facility, as shown on the
DRAWINGS; and construction quality control monitoring and testing. All procedures, operations and
methods shall be in strict compliance with the SPECIFICATIONS, Construction Quality Assurance Plan,
and the DRAWINGS.
1.02 SUBMITTALS:
A. CONTRACTOR shall provide the following information relating to the geomembrane
MANUFACTURER and INSTALLER with its proposal.
1. Information from the MANUFACTURER including company name, address, telephone
number, the names of the company president and quality control manager, and narrative
of the company history.
2. Information from the MANUFACTURER on factory size, equipment, personnel,
number of shifts per day, and capacity per shift.
3. Quality Control Manuals from the MANUFACTURER and INSTALLER for the
installation and testing of the geomembrane, including trial seams, seaming,
nondestmctive testing, destmctive testing procedures, repair procedures and in-field
quality control forms. Upon review of the Quality Control Manuals, MANAGER may
request additional testing during the manufacturing process at no additional cast to
• CC&V.
4. A list of at least five completed facilities from the MANUFACTURER totaling a
minimum of 5 million (5,000,000) square feet between all five facilities of the type of
geomembrane that is being installed at the Cresson Project. Each entry in this list
should specify the name and purpose of the facility, its location and date of installation,
the name of the owner, the project manager, designer, fabricator (if any), and the
geosynthetics installation contractor and the name and telephone number of the contact
at the facility who can discuss the project. in addition, the geomembrane thickness and
total square footage of the installation surface should be included.
5. Installation capabilities ofthe INSTALLER.
6. Information on equipment and personnel from the INSTALLER.
A list of at least five completed facilities, totaling five million (5,000,000) square feet
for which INSTALLER has installed the type of geomembrane that is being installed at
the Cresson Project. For each installation, the following information shall be provided:
a. Name and purpose of facility, its location, and date of installation.
b. Name of owner, Design Engineer, MANUFACTURER, Fabricator, if
applicable, and name and telephone number of contact at the facility who can
discuss the project.
c. Thickness of geomembrane and surface area of the installed geomembrane.
•
Section 02776 Page 1 of 20 October 25, 2000
Geomembrane Golder Associates Revision 8
1.W4fOBS\043-217W VC CERTIFfCA]iONREPORiU'HASE NC OSA CIX'MPPENDICSESWPPF]VDIX E iECEAiICAL SPECffICAiIONS\99J-209902TI61RB.DOC