Laserfiche WebLink
grain size. The material was then combined to meet the following specific grain-size <br />distribution outlined in the request for testing and shown below: <br />Sieve size::.::: ::Percent Passin . <br />1.0 inch 100 <br />318 inch 40-70 <br />N4 5-55 <br />N200 0-10 <br />The Soil Liner Fill material was processed by passing the bulk material through a li4 <br />sieve, moistening to approximately optimum moisture content and allowed to cure <br />overnight. <br />1.2 Geosynthetic Materials <br />One type of geomembrane material was submitted to Golder for use in the testing <br />process. The type of geomembrane was linear low density polyethylene (I.LDPE). The <br />specifics are shown below for the product: <br />Geos nth . <br />,F,... . . <br />100 mil LLDPE Textured surface on one side. <br />2.0 Test Apparatus <br />The apparatus used in for this test consists of a 10 inch inside diameter steel tube, <br />approximately 18 inches in height. A series of pictures showing the testing cell at <br />various stages of assembly is shown in Figures la and lb. The cell is attached to the <br />base plate with clamps while the tie-down rods anchored to the cell base plate extend <br />upward to allow the reaction force to be applied to the sample against the top plate. A <br />porous loading plate is placed in contact with the upper drainage material and a <br />hydraulic jack used to apply the force to the sample against the top plate. A digital <br />pressure transducer is used to monitor the applied load and dial gauges measure <br />deformation. The load from the hydraulic jack is adjusted to maintain the desired <br />loading stress throughout the test. <br />