Laserfiche WebLink
Memo to Tom Schreiner 2 February 21, 2006 <br />Bulkhead Cost Estimate Permit No. M-1983-141 <br />100 level adit, such discharge would be a regulated point source necessitating either adit plugging or water <br />management that may include long term water treatment. If the 100-level adit were to be plugged and <br />discharge at the Cash Shaft collar were to result, then the Cash Shaft may have to be plugged. For this <br />reason, DMG requires that the base level main bulkhead be designed for maximum potential hydraulic <br />head. This design basis has been employed at other permitted mines in Colorado, including the Sunnyside <br />Mine (Permit No. M-1977-372) and the Henderson Mine (Permit No. M-1977-342). The maximum <br />hydraulic head and pressure at the proposed main bulkhead are calculated as follows: <br />H = 8447'-7835'= 612 feet <br />Hyw 612 x 62.4 <br />p = z z = = 265 psi <br />144in / ft 144 <br />where: H =hydrostatic head (feet) <br />~„ =water density (62.4 pounds per square foot) <br />p =pressure head (psi) <br />Potential for Hydrofracing at the Proposed Main Bulkhead <br />The bulkhead must by constructed at a depth below ground surface that will provide sufficient overburden <br />pressure to prevent hydrostatic pressure from the impounded water hydrofracing the rock surrounding the <br />bulkhead. The hydrostatic pressure at which hydrofracing will occur is the formation breakdown pressure. <br />Intentional hydrofracing of rock from within drill holes is frequently undertaken by the petroleum industry <br />for the purpose of stimulating oil well production, and as a result has been intensively studied and is well <br />understood. In oil field applications, formation breakdown pressure (BP) is a function of (1) the tensile <br />strength of the rock immediately adjacent to the drill hole, (2) the in situ stress field in the plane <br />perpendicular to the drill hole, and (3) the pore pressure present in the formation. Bredehoeft, et al (1973) <br />presented the following equation for breakdown pressure: <br />BP = T, + (3 x S„~„) - 5,,,,,x - Pf <br />where: BP =breakdown pressure <br />TS =tensile strength <br />S,„;„ =minimum stress normal to the drill hole <br />S,„~ =maximum stress normal to the drill hole <br />Pf=formation pore pressure <br />all terms in psi <br />The equation can be simplified for the case of hydraulic pressure behind a bulkhead in an adit. The tensile <br />strength can be assumed to be zero because the adit wall rock is jointed and is fractured by blasting, and the <br />pore pressure in and near adit wall rock must be low and can be assumed to be zero. A simple assumption <br />is that hydrostatic stress conditions are equal to the overburden stress. This assumption is generally <br />conservative since the overburden stress must be present and the more general stress state measured is for <br />