Laserfiche WebLink
Exhibit C -Pre-Mining and Mining Plan Map(s) of Affected <br />Lands <br />The Map of Affected and Amended Lands included with this submittal is intended <br />to supplement existing information already presented under this same exhibit title <br />in the 1986 Amendment. There are several significant differences... <br />Permit boundaries are now clearly indicated along with distances between permit <br />corners. The original map utilized references to Section. Township rind Range, <br />but did no[ tie some unclear lines to a definite reference point, making <br />determination of the permit boundary on the ground difficult. <br />The updated information in this submittal utilizes Point A, (a stake I~~cated just <br />inside the corner post at the intersection of a durable fence line), and the fence <br />line running West from Point A as the beginning reference ling; for the <br />establishment of all permit corners and their resulting boundaries. <br />All distances and angles were measured utilizing a Total Station set up, and <br />resulting accuracy's are superior to the minimum establishment of such <br />boundaries utilizing the presently accepted minimum of a Brunton Compass and <br />Chain measurement. <br />The measurement is not a land survey and its sole purpose is to establish the <br />relative position of the permit boundary and all internally affected lands in a <br />manner that can be reasonably verified in the field, for the purposes of satisfying <br />all reasonable terms of this permit and its attending Rules and Regulations. All <br />other measurements necessary to identify the permit boundary relative to <br />property ownership (i.e. a legal land survey) can only be established by a <br />Registered Surveyor, the manner of which is not required under this permitting <br />authority. <br />Internal measurements of affected land were conducted by Measured Pace and <br />Compass and provide reasonable accuracy's for purposes of establishing warranty <br />estimates and assuring permit compliance. Note: Point W on the m:ap is not <br />included in the map Key, but represents an adjustment of the Pace and Compass <br />measurement of approximately l00 feet to better fit the estimated internal <br />measurements to line up with the access road established by Total Station <br />measurement. The different orders of accuracy made such adjustments possible <br />and necessary to better reflect actual field conditions. <br />All permit corners have been established on the ground based upon Total Station <br />measurement and will be similarly posted in the field to allow good line of sight <br />vision in the field. This will better assure the integrity of all permit boundaries <br />in the future. Actual markers in the field wilt be set approximately six to eight <br />Varra Companies. Inc. • Amendment of June 1995 • Jenkins Site • Iv1-77-393 <br />