Laserfiche WebLink
Paragon Analytics <br />METALS CASE NARRATIVE <br />CEMEX, Inc. <br />A and C Pit <br />Order Number - 0607003 <br />1. This report consists of 2 water samples. <br />2. The samples were received and intact on 07/01/06. The temperature of the samples <br />upon receipt was 8° Celsius. <br />3. The samples were to be analyzed for dissolved metals. The samples had not been <br />filtered and preserved prior to receipt. The samples were filtered through a 0.45 <br />micron filter and preserved with nitric acid to a pH less than two prior to analysis. <br />4. The samples were prepazed for analysis based on Methods for the Determination <br />of Metals in Environmental Samples -Supplement 1 procedures. <br />For analysis by ICP-MS, the samples were prepared following method 200.8 and <br />PA SOP 806 Rev. 12. The samples were not digested prior to analysis. <br />The samples were prepazed for ICP-MS analysis of selenium by passing the <br />samples and associated QC through a cation exchange column. The cation <br />exchange column removes, cations from the matrix. <br />5. The samples were analyzed following Methods for the Determination of Metals in <br />.Environmental Samples -Supplement 1 procedures. <br />Analysis by ICP-MS followed method 200.8 and PA SOP 827 Rev. 4. <br />The relationship between intensity and concentration for each element is <br />established using at least four standards, one of which is a blank solution. A <br />calibration equation relating instrument response to concentration is developed <br />by the instrument software. The equation is a higher order polynomial. This <br />type of equation is used to improve quantitation accuracy at lower <br />concentrations where the relationship between concentration and instrument <br />response is non-linear. <br />During sample analysis concentrations are computed by the software and the <br />results are printed in ug/L. The validity of the calibration equation is tested by <br />analyzing the following solutions: a blank, a low level check solution with <br />concentrations neaz the reporting limit, an Initial Calibration Verification (ICV) <br />