Laserfiche WebLink
r1 <br />L..J <br />NORTH <br />AMERICAN ~~ <br />GREEN <br />EROSION CONTROL Products <br />Cuoronteed SOLUTIONS <br />14649 HIGHWAY 41 NORTH <br />EVANSVILLE, IN 47725 <br />800-772-2040 <br />www.nagreen.com <br />~ >>~~~ ~ <br /> <br />- 123 CMj <br />1, PREPPRE SOIL BEFORE INSTAWNG ROLLED EROSION CONTROL PRODUCTS (RECP'a), INCLUDING ANY NECESSARY APPLICATION OF UME, FERTILIZER, AND SEED. <br />NOTE: WHEN USING CELL-O-SEED DO NOT SEED PREPARED AREA CELL-O-SEED MUST BE INSTALLED WRH PAPER SIDE DOWN. <br />2. BEGIN AT THE TOP OF THE CHANNEL BY ANCHORING THE RECP'a IN A 6' (15 CM) DEEP X 6' (15 CM) WIDE TRENCH WffH APPRO%IMATELY 12' 30 CM OF RECP'a <br />EXTENDED BEYOND THE UP-SLOPE PORDON OF THE TRENCH. ANCHOR THE RECPs WITH A ROW OF STAPLES/STAKES APPRO%IMATELV 12' (30 CM AP IN THE <br />BOTTOM OF THE TRENCH. BACKFlLL AND COMAPCT THE TRENCH AFTER STAPLING. APPLY SEED TO COMPACTED SOIL AND FOLD REMAINING 12' (30 CM) PORDON OF <br />RECP's BACK OVER SEED AND COMPACTED SOIL SECURE RECP's OVER COMPACTED SOIL WITH A ROW OF STAPLES/STAKES SPACED APPROXIMATELY 12' (30 CM) <br />ACROSS THE WIDTH OF THE RECP"a. <br />3. ROLL CENTER RECP'a IN DIRECTION OF WATER FLOW IN BOTTOM OF CHANNEL RECP'a WILL UNROLL WITH APPROPRIATE SIDE AGAINST THE SOIL SURFACE. ALL <br />RECP's MUST BE SECURELY FASTENED TO SOIL SURFACE BY PUGNC STAPLES/S7AKE5 IN APPROPRIATE LOC4770N5 AS SHOWN IN THE 57APLE PATTERN GUIDE. <br />WHEN USING THE DOT SYSTEM ,STAPLES/STAKES SHOULD BE PUCED THROUGH EACH OF THE COLORED DOTS CORRESPONDING TO THE APPROPRIATE STAPLE PATTERN. <br />PUCE CONSECUTNE RECP's END OVER END (SHINGLE STYLE) WITH A 4' - 6' (10 CM -15 CM) OVERIAP. USE A DOUBLE ROW OF STAPLES STAGCERW 4' (10 CM) <br />APART AND 4' (10 CMj ON CENTER TO SECURE RECP a. <br />5. FULL LENGTH EDGE OF RECP'c AT TOP OF SIDE SLOPES MUST BE ANCHORED WRH A ROW OF STAPLES/STARES APPRO%IMATELY 12' (30 CM) APART IN A 6' (15 CM) <br />DEEP X 6` (15 CM) WIDE TRENCH. BACKFlLL AND COMPACT THE TRENCH AFTER STAPLING, <br />6. ADJACENT RECP'a MUST BE OVERLAPPED APPRO%IMATELY 2' - 5` (5 CM -12.5 CM) (DEPENDING ON RECP'a TYPE) AND STAPLED. <br />7. IN HIGH FLOW CHANNEL APPLICATIONS, A STAPLE CHECK SLOT IS RECOMMENDED AT 30 TO 40 F00T (9 M - 12 M) INTERVALS. USE A DOUBLE ROW OF STAPLES <br />STAGGERED 4' (10 CM) APART AND 4' (10 CM) ON CENTER OVER ENTIRE WIDTH OF THE CHANNEL <br />8. THE TERMINAL END OF THE RECP'e MUST BE ANCHORED WffH A ROW OF STAPLES/STAKES APPRO%IMATELY 12' (30 CM) APART IN A 6` (15 CM) DEEP % 6' (IS CM) <br />WIDE TRENCH. BACKFlLL AND COMPACT THE TRENCH AFTER STAPLING. <br />NOTE: <br />• IN LOOSE SOIL CONORIONS, THE USE OF STAPLE OR STAKE LENGTHS GREATER THAN fi' (15 CM) MAY BE NECESSARY TD PROPERLY PNCHOR 7HE RECPs. <br /> NOTE: <br />A CRffICAL POINTS • HORIZONTAL STAPLE SPACING SHOULD BE ALTERED <br />B IF NECESSARY TO ALLOW STAPLES TO SECURE THE <br />A OVERLAPS AND SEAMS CRDICAL POINTS ALONG THE CHANNEL SURFACE. <br />~ <br />B. PROJECTED WATER LINE <br />' <br />C. CHANNEL BOTTOM/SIDE •• IN LOOSE SOIL CONDffI0N5, THE USE OF STAPLE <br />SLOPE VERTICES OR STAKE LENGTHS GREATER THAN 6' i5 cm) MAY <br />BE NECESSARY TO PROPERLY ANCHOR E RECP'a. <br /> <br />CHANNEL INSTALLATION (30 <br />( <br />• l <br />'• l <br />..." <br />:-:-:~:_ ~'-r-41 <br />a' (TO cM) <br />REV. 01/05 <br />