Laserfiche WebLink
2004 Geologic Hazard Field Observations <br />South of Divide Mining Area <br />• commonly is one-half the distance of the thickoess of the rock unit, or units, behaving as a plate <br />or beam. <br />Using this conceptual model of the overburden downwarping as multiple plates, the maximum <br />crack depth-the depth of the neutral surface-can be calculated by dividing the maximum <br />horizontal strain values by those of maximum curvature at a given location. The calculated depth <br />of the tension zone to the neutral surface--the boundary between tension above and compression <br />below--ranges from approximately 50 to 100 feet in the West Elk Mine monitoring network. <br />Crack depth may be much less than this projected 50-100 foot range of maximum values. An <br />unpublished study for the U. S. Btueau of Mines (Engineers International) indicated that surface <br />crack depth rarely is greater than 50 feet. Cracks will also be less extensive or terminate where <br />shale and claystone layers are present. <br />g the past nine years of annual observations in the West Elk Mining area (from 1996 to <br />2004 inclusive), particulazly the Apache Rocks and Box Canyon mining areas, no cracks were <br />• observed above mined-out langwall panels in colluvium more than an estimated ten feet thick. <br />No cracks were observed in the alluvium and colluvium in Deep Creek (overburden depth to the <br />mined B Seam ranges from about 950 to 1,050 feet) above mined longwall panels 15, 16, and 17 <br />during periodic field studies in the Apache Rocks and Box Canyon Mining areas. In addition, no <br />cracks were observed in the upper reaches of Sylvester Gulch above mined Iongwall panels 14, <br />15 and 16 (overburden thickness ranges from 800 to 1,600 feet). <br />• <br />No cracks have been observed in alluvium above mined-out longwall panels. <br />The neaz-surface alluvial material consists of primarily sand, silt, clay and soil is these two aeeas. <br />The areas were located above rigid pillars and panel boundaries where the overburden depth <br />ranges from 800 to 1,600 feet. A significant amotmt of the clay and silt in these stream areas has <br />been derived from the Wasatch Formation during processes of erosion and deposition. Based on <br />the observations in these two areas, it is unlikely that cracks will occur in colluvium and <br />alluvium in the stream valleys of the South of Divide Mining Area, because the alluvium and <br />colluvium contains more clay and silt than is present in the Deep Creek area (above mined <br />t431-032.621 WrigFrt Water Engineers, Inc. Page 16 <br />November 2004 <br />