PERMFILE68067 - Laserfiche WebLink

Home Browse Search

RECLAMATION BOND EVALUATION WORKSHEET SERIAL OR FILE NUMBER: COC-67276 MRLD NO. M-92-058 PROJECT NAME OR IDENTIFIER: MICA WHITE MINE, COLORADO QUARRIES, OWNER JOB DESCRIPTION: [1] P1T RECLAMATION [2] ROAD RECLAMATION BASIC CONDITIONS AND ASSUMPTIONS: PIT RECLAMATION. The final configuration of the pit as planned by Colorado Quarries is shown on the attached Map. The shape in Plan will be an elongated oval. The overall average dimensions will be approximately 815 feet long by 300 feet wide, which total approximately 5.7 acres. It will consist of a number of benches, shown on the map, with a pit floor of approximately 2.0 acres. Because of narrow bench width, dozer size will be restricted to no larger than a John Deere 550 or a Caterpillar D-4. In these calculations, it is assumed that each bench with south-facing slope (8'-10' wide) would require 2 passes with adozer-pulled ripper, one going to the end of the bench and one returning. (For these benches, the two passes would overlap). Each bench with north-facing slope (12" wide) also will require 2 passes with adozer-pulled ripper (these will not overlap or will overlap slightly). Maximum assumed speed would be'h mph [44 ft./min]. A 2 minute turn-around time is assumed in moving up or down from one bench to another. 75% efficiency also is assumed. To simplify calculations the bench area was divided into 11 blocks, which were overlain on Map I (but not included herein). Blocks on south-facing slopes will require 2 passes with the dozer; blacks on northfacing slopes will require 3 passes with the dozer. Dozer time was calculated separately for each block and then totaled. This was then multiplied by the cost/minute to get asub-total for each block. The pit floor was arbitrarily divided into 15 12-foot wide strips for purposes of calculation. Because of overlap of dozer passes, it was assumed that each strip would require 2'/x passes of the dozer. II also was assumed that 2 minutes would be used to turn around at the end of each pass, and because of the fairly flat surface, an efficiency of 80% was assumed for this part of the operation. Machinery costs estimates were provided by Colorado Machinery, 685 Enterprise Drive, Pueblo Wert, 81007. Estimate used John Deere Model SSOH, renting at $300.00 per day. JOB DESCRIPTION: UNIT COST NUMBER OF UNITS SUBTOTALS/ PIT RECLAMATION TOTAL BLOCK A $300/day @ 8 11 benches totaling 1369 feet @ 44 DOZING & hrs/d = $0.625 ft/min X 2 = 62 mins + 12 mins $60.00 RIPPING per minute [75% efficiency] + 22 mins [turn- BENCHES around time] = 96 minutes BLOCK B 13 benches totaling 2479 ft @ 44 DOZING & Same as above ft/min X 2 = 112 mins + 22 mins $100.00 RIPPING [75% efficiency] + 26 mins [turn- BENCHES around time] = 160 minutes BLOCK C 13 benches totaling 1319ft @ 44 DOZING & Same as above ft/min X 2 = 60 mins + 12 mins $61.25 RIPPING [75% efficiency] + 98 mins [turn- BENCHES around time] = 64 minutes