Laserfiche WebLink
Subsidence Evaluation For <br />Exhibit 608 South of Divide Mining Area <br />U <br />panel barrier or chain pillars and to the caved gob and the mining face (Dunrud 197. Stresses <br />temporarily increase in the zones of these compression azches. However, the arches in a given <br />area commonly move upward and dissipate as longwall mining is completed in that area. Arches <br />may not dissipate where the room-and pfllaz mining method is used, because pillars and stumps <br />left after mining can prevent dissipation of the compression arches. The overburden rocks <br />affected by the arches are temporarily subjected to increased stress and strain as the arches move <br />upwazd. In longwall mining aeeas, this increased stress and strain commonly are less than in <br />room-and-pillaz mining areas because stresses are relieved as the arches move upwazd and <br />dissipate. <br />Peng (1992, p.4) reports that the combined height of the zone of caving and fracturing ranges <br />from 20t to 30t, and that the height of the fractured zone is greater for hard, strong rocks than for <br />soft, weak rocks. <br />The height of the zone of fracturing is a function of lithology and layer thickness, according w <br />Peng (1992, p. 6-8). For example, the zone of fracturing commonly is higher for strong, thickly- <br />bedded, brittle sandstones than it is for thinly layered, soft, shales and claystones. Liu (1981) <br />reports ranges of heights of the zone of Iacturing for various rock types as follows: <br />1. Heights of 20t to 30t are reported in strong brittle rocks, such as siliceous sandstones and <br />limestones; a value of 28t was reported for overburden containing 70 percent sandstone. <br />Also, because of hazdness, fractures do not close as readily in brittle rocks as they do in <br />soft rocks during recompression. <br />2. Heights of 9t to l It are reported where all the rocks consist of soft shales and claystones. <br />The fractures also commonly close again under stresses associated with static conditions, <br />and become impermeable again. <br />According to Mr. Koontz, lOt to 20[ is a good projection for the height of fracturing in the <br />Apache Rocks and Box Canyon mining areas. However, a projected fracture height of 30 times <br />the coal extraction thickness (30t) may locally occur (Koontz, oral communication March 2004). <br />Within the South of Divide mining area, the fracture zone may become less continuous in the <br />caved zone with increasing height because of the alternating sequence of harder and brittle rocks <br />and softer and yielding rocks. The height of the fracture zone, therefore, will likely beless-by <br />possibly 10 to 20 percent~lran the height predicted for the Apache Rocks and Box Canyon <br />mining areas because of the presence of more shale above the E Seam mining in the South of <br />Divide mining area. Fractures neaz the top of the caved zone, therefore, will likely become less <br />continuous with increasing height in the zone of fracturing. <br />The maximum height of fracturing above longwall panels in the South of Divide mining area is <br />estumated to range from about lOt to 20t. This is near the mid-range of 9t to 30t as reported by <br />Peng (1992, p. 7). This estimate may be conservative for the particulaz rock strata or lithology <br />above the E Seam. When considering a conservative 10 percent reduction for Ure softer rocks <br />overlying the E Seam, the effective height of fracturing in the South of Divide mining area is <br />. estimated to range from 9t to 18t. <br />839-Q32.690 WiightWaterEngineers lnc. <br />