HYDRO20117

• Permit No: C1980005
• IBM Index Class Name: Hydrology
• Doc Date: 7/11/2005
• Doc Name: 2nd Quarter 2005 Inspection Report
• From: Seneca Coal Company
• To: DMG
• Permit Index Doc Type: Sediment Pond Inspections
• Media Type: D
• Archive: No

PHRIODIC INSPECTION FORM
' Water, Sediment, or Slurry I//m'~poun^^dffinents
INSPECTOR'S NAME: Dennis Jones DATE: b '~ O~"~ 5
FADILITYDCONFIGURATIOONOODiked Pond 003 DATE LAST INSPECTION: 3'a 1' 0 S
SITE NAME: Northwest Impoundment #003 LOCATION: SE',{ SW;{, Sec. 27, T6N, R87W
MINE NAME: Seneca II Mine (Seneca Coal Co) LOCATION: 7.1 mi. SE of Hayden, CO
MINE I.D. NO.: CMLRD Permit No. C-80-005 OWNER'S REP.: Gregg Kitchen, Gen Mgr
Circle or write is appropriate response
1
2
3
4
5
6
7.
8.
9.
10
I1
12
13
14
15
16
17
18
19
Foundation preparation (removal of vegetation, stumps, topsoil: Yes
Lift thickness: 12 in.
Compaction according to approved plan: Yes
Burning (specify extent and location): No
Angle of slope: 2:1 upstream, 3:1 downstream Total = 5:1
*Seepage (specify location, color, and approximate volume)
From underdrain pipes:
At isolated points on embankment slopes:
At natural hillside:
Over widespread areas;
From downstream foundation area:
"Boils" beneath stream or ponded water:
Cracks or scarps on crest:
Cracks or scarps on slope:
Sloughing or bulging on slope:
*Major erosion problems:
Surface movements in valley bottom or on hillside:
*Erosion of toe:
*Water impounded against toe:
Existing embankment freeboard: (normal = 4.9')
Increase Decrease in water level: k,~ c~a4~
Cracks, bulging, or erosion on upstream face:
Visible sumps or sinkholes in slurry surface:
*Clogging
Spillway channels and pipes:
Decant system:
Diversion ditches:
*Cracking or crushing of pipes
N/A
Yes No N/A
Yes No N/A
Yes No N/A
Yes No N/A
Yes No N/A
Yes No N/A
Yes No N/A
Yes No N/A
Yes No N/A
Yes No N/A
Y05 NO N/A
Yes No N/A
~j.9 feet
_ feet
Yes ~ N/A
N/A
Yes No N/A
N/A
Y2S NO N/A
Spillway pipes: Yes
Decant system: N/A
20. Trash racks clear and in place: Yes
CN~ N/A
No N/A
*Major adverse changes in these items could cause instability and should be reported to the
Engineering Manager and Mine Superintendent for further evaluation. Adverse conditions noted in
these items should normally be described (extent, location, volume, etc.) in the space on the
back of this sheet.