Laserfiche WebLink
Bear Creek <br />• SAE-B The area protected by this SAE is the Bear Creek <br />portal area. The only facilities remaining in the <br />area are some concrete foundations and a partially <br />dismantled substation. Run-off from the area will <br />be contained by a berm. A silt fence is installed <br />at the low point in the yard. Run-off from the <br />yard will either be contained by the berm or will <br />be filtered by the silt fence. A pipe with a silt <br />fence at its inlet drains water from the bermed <br />area. The sample point will be the discharge end <br />of the pipe. <br />SAE-9 Reserved. <br />Lower Hubbard Creek <br />SAE-10 The area protected by this SAE is the lower Hubbard <br />Creek ventilation facility. The only facilities <br />remaining are concrete foundations and two concrete <br />portals. Run-off from the yard will be contained <br />by a berm. A silt fence is installed at the low <br />point in the yard. Run-off from the yard will <br />either be contained by the berm or will be filtered <br />by the silt fence. A pipe with a silt fence at its <br />inlet drains water from the bermed area. The <br />sample point will be the discharge end of the pipe. <br />~'~ <br />SAE-11 The area protected by this SAE is the lower Hubbard <br />Creek hoist house pad. The only facility remaining <br />is the concrete foundation. Run-off from the pad <br />will be contained by a berm. A silt fence is <br />installed at the low point on the pad. Run-off <br />from the pad will either be contained by the berm <br />or will be filtered by the silt fence. A pipe with <br />a silt fence at its inlet drains water from the <br />bermed area. The sample point will be the <br />discharge end of the pipe. <br />Sanborn Creek Portals <br />See discussion beginning on page B-86 and sections <br />2.05.3(4) and 2.05.6(3)(b)(iv). <br />Small Area Exemption Demonstrations <br />Upper Hubbard Creek Pond Outslope <br />The Upper Hubbard Creek sediment pond outslope was <br />modeled using the computer program Sedcad+ Versio n <br />3. The modeling was performed to determine if run - <br />• B-141 <br />