Laserfiche WebLink
Newmontf., CRIPPLE CREEK & VICTOR <br /> PO Box 191 <br /> CRIPPLE CREEK &VICTOR 1ictorC Street <br /> Victor CO 80860 <br /> 1-250 mL HDPE filtered sample(grab sample)preserved with 1.25 mL HNO3(Nitric Acid, red label) <br /> Disposable gloves will be worn during the collection and preservation of samples <br /> to minimize potential contamination of the sample, and to protect hands from <br /> preservatives and process water. <br /> When filling containers leave a small air space to allow for thermal expansion <br /> unless sampling for organics or dissolved oxygen which requires zero head space. <br /> 8.2. Field Sample Field Sheets <br /> A detailed record will be made at the time of collection of all pertinent information <br /> related to the sample. See Field Data in the previous section (Section 7.1) for <br /> appropriate information. For locations requiring low-flow sampling protocols, a <br /> field sample sheet will be used to record stabilization criteria; these criteria include <br /> • field parameters such as pH, conductivity, temperature, etc. An example low-flow <br /> field sheet is included as Appendix C. <br /> 8.3. Sample Identification <br /> p <br /> Gummed paper labels or tags will be filled out with waterproof ink at the time the <br /> sample is collected. The labels should contain the following information: date and <br /> time of sample collection, sample location, sample identification (ID#), initials of <br /> sample collector, whether the sample was filtered, and type of preservative used. <br /> The labels must be attached to the appropriate sample bottle. In the absence of <br /> labels, write the above information directly on the sample bottle with a permanent <br /> marker. <br /> Care must be exercised to ensure that the sample ID# is the same as the official <br /> designation for each sample location. Failure to use the same ID# as specified in <br /> the applicable permit may result in analytical results being questioned. Officially <br /> designated sample ID's for compliance sampling locations are specified in <br /> appendix G. Non-compliance samples to be collected shall be collected as <br /> necessary, with the all necessary information being recorded on the sample field <br /> data sheet. It is extremely important that sample identification and recorded <br /> • notes be sufficient to identify precisely where the samples came from. <br /> Department THIS DOCUMENT IS UNCONTROLLED IN HARD COPY FORMAT Doc Id: <br /> SLR Date of This Issue--/--/-- Date of Next Review:--/--/-- Page 21 of 73 <br />