2022-10-12_PERMIT FILE - P2022017

Home Browse Search

MATERIAL SAFETY DATA SHEET Trade Name: POLY-PLUS* MSDS NO. 10094 Revision Date: 09/20/2004 Page 3/6 Environmental Precautions: Do not allow to enter sewer or surface and subsurface waters.Waste must be disposed of in accordance with federal, state and local laws. In the U.S.,for products with reportable quanitity(RQ)components- if the RQ is exceeded, report to National Spill Response Office at 1 800 424 8802. 7. HANDLING AND STORAGE -771 Handling: Put on appropriate personal protective equipment. Avoid contact with skin and eyes. Avoid breathing vapors or spray mists. Use only in a well ventilated area. Spilled product is very slippery. Wash thoroughly after handling. Storage: Store in dry,well-ventilated area. Keep container closed. Keep away from heat, sparks and flames. Store away from incompatibles. Follow safe warehousing practices regarding palletizing, banding,shrink-wrapping and/or stacking. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Exposure Limits(TLV& PEL- 8H TWA): Ingredient CAS No. Wt.% ACGIH TLV OSHA PEL Other Notes Anionic polyacrylamide 20-40 NA NA NA 1 6 Petroleum distillates, 64742-47-8 20-40 NA NA N (3)Oil mist. h drotreated li ht Notes (1) Control as an ACGIH particulate not otherwise specified (PNOS): 10 mg/m3(Inhalable); 3 mg/m3(Respirable)and an OSHA particulate not otherwise regulated (PNOR): 15 mg/m3(Total); 5 mg/m3(Respirable). (3) For Oil mist, mineral: ACGIH TLV 5 mg/m3, STEL 10 mg/m3; OSHA PEL 5 mg/m3 (6)Ammonia or amines may be released when this component is heated or exposed to high pH. The recommended exposure limits for ammonia are ACGIH TLV 25 ppm and OSHA PEL 50 ppm. No general recommended exposure limit is available for amines.A NIOSH/MSHA approved respirator with ammonia/methylamine cartridges should be used to protect against ammonia or amine inhalation exposure. Engineering Controls: Local exhaust ventilation as necessary to maintain exposures to within applicable limits. Personal Protection Equipment Eye/Face Protection: Wear chemical safety goggles. Skin Protection: Wear appropriate clothing to prevent repeated or prolonged skin contact. Wear chemical resistant gloves such as nitrile or neoprene. Respiratory Protection: If exposed to particulates/aerosols: Use at least a NIOSH-approved N95 half-mask disposable particulate respirator. In work environments containing oil mist/aerosol use at least a NIOSH-approved P95 half-mask disposable or reuseable particulate respirator. If exposed to organic vapors: Use a NIOSH/MSHA-approved organic vapor respirator. CCROV: CCR with organic vapor cartridge. A NIOSH/MSHA approved respirator with ammonia/methylamine cartridges should be used to protect against ammonia or amine inhalation exposure. Refer to Exposure Limits table(Section 8)for component specific respiratory protection recommendations. General Hygiene Considerations: Wash promptly with soap and water if skin becomes contaminated. Change work clothing daily if there is any possibility of contamination.