Laserfiche WebLink
, , . <br /> 3. All of the raw input data (i.e., meter readings, water pumped from wells, etc.) must be provided and <br /> organized in a single tocation, such as an "Input" worksheet, etc. The accounting must include the <br /> following input data listed below, as well as relevant WDIDs and permit numbers. <br /> a. Diversion data from flumes or weirs and unit of ineasurement. <br /> b. The required input data for each weil is: <br /> i. the monthty flow meter readin� as shown on the flow meter; date of the meter reading; <br /> flow meter multiplier (i.e., 0.001, 10, 1 i; units of volume (i.e., gallons or acre-feet); the <br /> meter serial number; correction factor, if any. <br /> ii. The totat volume pumped, showing the catculations using the information in Item "i" <br /> above. <br /> iii. factors from the decree or SWSP that provide for the wetl consumptive use and deptetions <br /> (i.e., presumptive depletion factor (PDF), water balance methodology, lagging parameters, <br /> etc.). <br /> iv. Any wetl permitted or decre�d as an alternate point of diversion (APOD) to a surface water <br /> right must rer�ort �um�� on a daity basis if any of the diversions during the month is <br /> claimed as bein� "in priority". (See Administration Protocol-APOD Wells for more details.) <br /> c. If appticable, data for each recharge structure must be induded and comply with the appropriate <br /> decree(s) or SWSP Approval requirements and any applicabte current statewide Administration <br /> Protocol. At a minimum the foltowing should be reported in the accounting: <br /> i. 7-digit WDID and name of recharge structure <br /> ii. daily volume in AF diverted into the site; <br /> iii. monthly volume in AF reteased from the site; <br /> iv. monthly gross evaporative toss in AF; <br /> v. volume of water in AF remaining at the end of the month. <br /> d. The accounting must identify each source of replacement water actually delivered to the stream <br /> and how replacement water at that location offset the deptetions. To demonstrate the water was <br /> actually detivered to the required tocation will require the following information: <br /> i. the name (water court case, tease, etc.) and WDID of the originating source of the <br /> replacement water, date reteased and volume of water released; <br /> ii. transit tosses from point of release to point of deptetion or use, if any, using stream loss <br /> factors approved by the water commissioner; <br /> iii. the volume of water actually delivered on a daily basis past any surface water diversion <br /> that was sweeping the river as corroborated by the water commissioner. (See <br /> Administration Protocol- Delivery of Water for more details on delivering water). <br /> For each source of replacement water that has been"changed"for use as a source of augmentation, <br /> such as changed reservoir shares, changed rights from a ditch, or credits from dry-up, etc., the <br /> following input information must be reported: <br /> i. the decreed volume of return flow obligation; <br /> ii. if not specified in the decree or SWSP, the location and timing of the owed return ftow on <br /> the stream(s). <br /> 4. if required by the decree or SWSP, the accounting must inctude a monthty projection of the plan's operation <br /> at least through March 31 of the next calendar year, or as specified in the decree or SWSP. <br /> 5. The accounting submittal must include output associated with modeling showing monthly delayed <br /> depletions (from well pumping or return flow obligations) and/or accretions (from recharge). <br /> Questions can be submitted to Ask DWR by visiting the DWR homepage at: dwr.colorado.eov/ Page 2/3 <br />