Laserfiche WebLink
<br /> Page 2 of 9 <br />Annual Emission Limits: <br />Facility Equipment ID AIRS <br />Point <br />Tons per Year Emission <br />Type <br />PM PM10 PM2.5 NOx CO <br />Mining and Hauling <br />Operations <br />001 <br />38.1 15.9 1.4 - - Fugitive <br />Transfer Points 6.8 2.5 0.4 - - Point <br />Blasting Operations 1.1 0.6 - - 20.1 Point <br /> <br />Note: In the absence of credible evidence to the contrary, c ompliance with the emission <br />limits is demonstrated by complying with the production limits listed below and by <br />following the attached particulate emissions control plan. <br /> <br />3. The following control equipment must be maintained and operated to ensure satisfactory <br />performance. The owner or operator must monitor compliance with this condition through the <br />results of approved compliance tests (when required), compliance with the Operating and <br />Maintenance Plan, compliance records, and other methods as approved by the <br />Division. (Reference: Regulation Number 3, Part B, Section III.E.) <br />Facility Equipment ID AIRS Point Control Device Controlled Pollutants <br />Transfer point 001 Water spray bars PM <br />Drilling 001 Bag Collector PM <br /> <br />PROCESS LIMITATIONS AND RECORDS <br /> <br />4. This source must be limited to the following maximum consumption, processing and/or <br />operational rates as listed below. Daily and annual records of the actual process rate must be <br />maintained by the applicant and made available to the Division for inspection upon request. <br />(Reference: Regulation Number 3, Part B, II.A.4) <br /> <br />Production Limits: <br />AIRS <br />Point <br />Production Parameter Daily Limit <br />(tons/day) <br />Annual Limit <br />(tons/year) <br />001 <br />Sand and gravel extraction 11,600 2,250,000 <br />ANFO use - 600 <br /> <br />STATE AND FEDERAL REGULATORY REQUIREMENTS <br /> <br />5. Visible emissions from conveyors and transfer points must not exceed twenty percent (20%) <br />opacity during normal operation of the source. During periods of startup, process modification, <br />or adjustment of control equipment visible emissions must not exceed 30% opacity for more <br />than six minutes in any sixty consecutive minutes. (Reference: Regulation Number 1, II.A.1. & <br />4.) <br /> <br />6. All conveyors and transfer points will be subject to the New Source Performance Standards <br />requirements of Regulation number 6, Subpart OOO whenever there is primary crushing <br />capacity greater than 150 tons per hour (portable equipment) or 25 tons per hour (fixed <br />equipment) at this location as follows: <br />