Laserfiche WebLink
corrective measures installed in 1997 and 1998. However, due to the limited time that the <br />structures have been in place, MCC has not had sufficient time to evaluate the effectiveness of these <br />structures for the long term (i.e. post -reclamation). MCC is continuing to collect water level data <br />and movement data from the various piezometers, inclinometers, and survey mirrors around the <br />mine site on a scheduled interval. Based on the data collected, MCC will reevaluate the slope <br />stability analyses after the spring runoff each year and where appropriate, update Exhibit 14C. The <br />update will include an evaluation of the relative change in the factor of safety during the previous <br />year and since the installation of the corrective measure in 1998. A revision including the updated <br />information will be provided to the Division by July 30'' of each year. In addition, after at least five <br />years of data collection, MCC will reevaluate the reclamation plan in 2003, and modify as <br />necessary to ensure that the mine will continue to be stable upon final reclamation. Seedbed quality <br />material is removed from the temporary stockpile and distributed uniformly over the areas to be <br />revegetated. Areas within the mine site are revegetated after construction using the permanent seed <br />mix listed in Table 37 except for selected Areas which are landscaped to provide a pleasant <br />working environment. Lower soil horizons are used for fill as subsoil base in order to obtain an <br />overall soil depth necessary to enhance and sustain plant growth. Following topsoiling, and prior to <br />planting, nutrients and soil amendments are added if needed to establish vegetative growth. <br />Reseeded areas are mulched or the seed raked in to the soil. <br />The West Elk Mine site will be returned to approximate original contour (AOC) as shown on Maps <br />58 and 59. However, not all material excavated from specific areas is required to be returned to <br />achieve AOC. One of these areas is the expanded materials storage bench (MSB) which occurred in <br />1997. Approximately 16,000 cy of material was excavated to the west of the existing cutslope of <br />the MSB to reduce the slope from 1.5:1 to 2.25:1, improving slope stability in this area of the MSB. <br />Approximately 4,000 cy of topsoil was stockpiled in Topsoil Stockpile #5. Approximately 2,000- <br />3,000 cy of subsoil was used to repair and regrade slopes in the portal bench storage area and below <br />the mine supply storage light -use road. The remaining 10,000 cy was placed on the east end of the <br />MSB as an engineered fill to expand the surface area of the MSB. The subsoil used to repair and <br />regrade nearby slopes will not be returned to the MSB during final reclamation, and as shown on <br />Map 58B will not be needed to achieve AOC. The reclamation of all areas will be such that the <br />areas will be stable, the hydrologic balance will not be impacted, topsoil will be salvaged, stored <br />and replaced, and the disturbed areas will be revegetated. <br />When the surface facilities are removed and the site regraded, the topsoil will be redistributed to a <br />depth of 12 -18 inches over areas of the main mine facilities and 24 inches over areas in the <br />Sylvester Gulch Facilities Area. These surfaces will be revegetated using permanent vegetation seed <br />and the seedling mixtures. Fertilizer and mulch will be applied in accordance with the Topsoil <br />Preparation Section. <br />Roads <br />When no longer needed for mining operations, the primary haul/access roads and other access and <br />light -use roads not approved as permanent facilities will be removed and the areas reclaimed. The <br />roads will be filled and graded to the approximate original contour (unless the roads were part of <br />the riginal contour). Topsoil will be spread over these areas to a 12 to 18 inch depth for reclaimed <br />1.05-61 Revised Noe 1996PR07; Rev. Jam 1997TR79; Rev. Sept 1997 MR 227, -Rev. Apr112006PR10 <br />