Laserfiche WebLink
Standards Information <br /> Standard solutions for these analysis are NIST traceable or verified with a NIST traceable standard and used <br /> before the expiration dates. <br /> Sample Geometry <br /> All counting sources were prepared in the same geometry as the calibration standards. <br /> Quality Control(QC)Information: <br /> Blank Information <br /> The blank volume is representative of the sample volume in this batch. <br /> Designated QC <br /> The following sample was used for QC: 344616001 (Sunday MW 1). <br /> QC Information <br /> All of the QC samples met the required acceptance limits. <br /> Technical Information: <br /> Holding Time <br /> All sample procedures for this sample set were performed within the required holding time. <br /> Sample Re-prep/Re-analysis <br /> None of the samples in this sample set required reprep or reanalysis. <br /> Recounts <br /> Sample 1203052244(LCSD)was recounted due to low recovery.The recount is reported. <br /> Miscellaneous Information: <br /> Data Exception(DER)Documentation <br /> Data exception reports are generated to document any procedural anomalies that may deviate from referenced <br /> SOP or contractual documents.A data exception report(DER)was not generated for this SDG. <br /> Sample-Specific MDA/MDC <br /> The MDA/MDC reported on the certificate of analysis is a sample-specific MDA/MDC. <br /> Additional Comments <br /> Additional comments were not required for this sample set. <br /> Qualifier Information <br /> Manual qualifiers were not required. <br /> Certification Statement <br /> Where the analytical method has been performed under NELAP certification,the analysis has met all of the <br /> requirements of the NELAC standard unless otherwise noted in the analytical case narrative. <br /> Page 81 of 94 <br />