Laserfiche WebLink
QUADRAFROTH P75 <br /> Section 8. Exposure controls/personal protection <br /> Control parameters <br /> Occupational exposure limits <br /> Ingredient name Exposure limits <br /> Pine oil None. <br /> 4-m ethyl pentan-2-ol ACGIH TLV(United States, 3/2018). <br /> Absorbed through skin. <br /> TWA: 25 ppm 8 hours. <br /> TWA: 104 mg/m'8 hours. <br /> STEL: 40 ppm 15 minutes. <br /> STEL: 167 mg/m' 15 minutes. <br /> OSHA PEL 1989 (United States, 3/1989). <br /> Absorbed through skin. <br /> TWA: 25 ppm 8 hours. <br /> TWA: 100 mg/m'8 hours. <br /> STEL: 40 ppm 15 minutes. <br /> STEL: 165 mg/m' 15 minutes. <br /> NIOSH REL(United States, 10/2016). <br /> Absorbed through skin. <br /> TWA: 25 ppm 10 hours. <br /> TWA: 100 mg/m' 10 hours. <br /> STEL: 40 ppm 15 minutes. <br /> STEL: 165 mg/m' 15 minutes. <br /> OSHA PEL (United States, 5/2018). <br /> Absorbed through skin. <br /> TWA: 25 ppm 8 hours. <br /> TWA: 100 mg/m'8 hours. <br /> Appropriate engineering Use only with adequate ventilation. Use process enclosures, local exhaust ventilation or <br /> controls other engineering controls to keep worker exposure to airborne contaminants below any <br /> recommended or statutory limits. The engineering controls also need to keep gas, <br /> vapor or dust concentrations below any lower explosive limits. Use explosion-proof <br /> ventilation equipment. <br /> Environmental exposure Emissions from ventilation or work process equipment should be checked to ensure <br /> controls they comply with the requirements of environmental protection legislation. In some <br /> cases, fume scrubbers, filters or engineering modifications to the process equipment <br /> will be necessary to reduce emissions to acceptable levels. <br /> Individual protection measures <br /> Hygiene measures Wash hands, forearms and face thoroughly after handling chemical products, before <br /> eating, smoking and using the lavatory and at the end of the working period. <br /> Appropriate techniques should be used to remove potentially contaminated clothing. <br /> Wash contaminated clothing before reusing. Ensure that eyewash stations and safety <br /> showers are close to the workstation location. <br /> Eye/face protection Safety eyewear complying with an approved standard should be used when a risk <br /> assessment indicates this is necessary to avoid exposure to liquid splashes, mists, <br /> gases or dusts. If contact is possible, the following protection should be worn, unless <br /> the assessment indicates a higher degree of protection: chemical splash goggles. <br /> Skin protection <br /> Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be <br /> worn at all times when handling chemical products if a risk assessment indicates this is <br /> necessary. Considering the parameters specified by the glove manufacturer, check <br /> during use that the gloves are still retaining their protective properties. It should be <br /> noted that the time to breakthrough for any glove material may be different for different <br /> glove manufacturers. In the case of mixtures, consisting of several substances, the <br /> protection time of the gloves cannot be accurately estimated. <br /> Date of issue/Date of revision :111812019 Date of previous issue :111812019 Version :1.01 5111 <br />