2019-03-01_INSPECTION - C1982056

Home Browse Search

(3) If the 6 -minute average opacity readings are less than or equal to half the applicable opacity limit (all 6 -minute averages are less than or equal to 10.;), then the observation period may be reduced from 1 hour to 30 minutes. (4) A visible emissions observer may conduct visible emission observations for up to three fugitive, stack, or vent emission points within a 15 -second interval if the following conditions are met: No more than three emissions points may be read concurrently. All three emissions points must be within a 70 degree viewing sector or angle in front of the observer such that the proper sun position can be maintained for all three points. If an opacity reading for any one of the three emissions points is within 5 percent opacity from the applicable standard (excluding readings of zero opacity), then the observer must stop taking readings for the other two points and continue reading just that single point. C. Initial performance tests are required for the following point(s): AIRS ID point 211 at the exhaust outlet for any control device. d. Results of initial performance tests must be submitted to the APCD (Administrator or delegated authority), consistent with the provisions of section 60.8. e. After July 1, 2011, within 60 days after the date of completing each performance evaluation conducted to demonstrate compliance with this subpart, the owner or operator of the affected facility must submit the test data to EPA by successfully entering the data electronically into EPA's WebFIRE data base available at http://cfoub.epa.Qov/oarweb/index.cfm?action=fire.main. For performance tests that cannot be entered into WebFIRE (i.e., Method 9 of appendix A-4 of this part opacity performance tests) the owner or operator of the affected facility must mail a summary copy to United States Environmental Protection Agency; Energy Strategies Group; 109 TW Alexander DR; mail code: D243 01; RTP, NC 27711. A written copy must be submitted to the Division. In addition, the following requirements of Regulation No. 6, Part A, Subpart A, General Provisions, apply. At all times, including periods of start-up, shutdown, and malfunction, the facility and control equipment must, to the extent practicable, be maintained and operated in a manner consistent with good air pollution control practices for minimizing emissions. Determination of whether or not acceptable operating and maintenance procedures are being used will be based on information available to the Division, which may include, but is not limited to, monitoring results, opacity observations, review of operating and maintenance procedures, and inspection of the source. (Reference: Regulation No. 6, Part A. General Provisions from 40 CFR 60.11 g. No article, machine, equipment or process must be used to conceal an emission that would otherwise constitute a violation of an applicable standard. Such concealment includes, but is not limited to, the use of gaseous diluents to achieve compliance with an opacity standard or with a standard that is based on the concentration of a pollutant in the gases discharged to the atmosphere. (S 60.12) h. Records of startups, shutdowns, and malfunctions must be maintained, as required under S 60.7. Compliance with opacity standards must be demonstrated according to 5 60.11. ®� COLORADO Air Pollution Control Division Oewlwtent of P[t6Lc Health 6 Enwtxvnent Page 5 of 26