Laserfiche WebLink
PART <br />0 A. DEFINITION OF EFFLUENT LIMITATIONS <br />1. Effluent Limitations <br />PART <br />Permit No. CO -0029599 <br />Page No. 3 <br />Beginning no later than the effective date of this permit and lasting through June 31, 2006, the permittee is authorized <br />to discharge from outfalls 001 and 005. <br />In accordance with the Water Quality Control Commission Regulations for Effluent Limitations, Section 62.4, and the <br />Colorado Discharge Permit System Regulations, Section 61.8(2), 5 C.C.R. 1002-61, the permitted discharge shall not <br />contain effluent parameter concentrations which exceed the following limitations specified below or exceed the <br />specified flow limitations. <br />a. Outfall 001 <br />Flow, MGD 0.25 Report <br />Oil and Grease, mg/! N/A 10 <br />pH, s.u. (Minimum -Maximum) <br />N/A <br />6.5-9.0 <br />Total Suspended Solids, mg/f <br />35 <br />70 <br />Total Dissolved Solids, mg/f <br />Report <br />Report <br />Whole Effluent Toxicity, Chronic <br />N/A <br />See Part I.A.I.b. <br />Potentially Dissolved Cadmium, mg1P <br />0.0021 <br />Report <br />. Potentially Dissolved Iron, mg/1 <br />Total Recoverable Iron, mg/1 <br />0.431 <br />0.957 <br />Report <br />Report <br />b. Whole Effluent Toxicity -Chronic Lethality Limitation for Outfall 001 <br />Beginning immediately and lasting through June 30, 2006, there shall be no statistically significant difference in <br />lethality (at the 95% confidence level) between the control and any effluent concentration less than or equal to 66% <br />effluent. Such limitation shall apply as a daily maximum. <br />c. Outfall 005 <br />Flow, MGD Report Report <br />Settleable Solids, mf/Q■ NA 0.5 <br />Oil and Grease, mg/f N/A 10 <br />pH, s.u. (Minimum -Maximum) N/A 6.5-9.0 <br />Total Dissolved Solids, mg/f Report Report <br />• Any discharge or increase in the volume of a discharge caused by precipitation within any 24-hour period may <br />comply with alternate limitations subject to burden of proof requirements described in Part I.A.3. See Part I.A.3. <br />for an explanation of when these limitations apply. <br />0 See Part I.C. for Definitions. <br />