2018-09-04_PERMIT FILE - C1981019A

Home Browse Search

RULE 4 PERFORMANCE STANDARDS approximately parallel to the dip of the numerous coal seams. The initial box cut for the operation was made on the south side of Streeter Draw. The mining operation is designed to progress in a southward direction with shovels/trucks/ proceeding along the entire length of the mining area uncovering the upper coal seams and the draglines uncovering the lower coal seams as shown on the mining range diagram (Map 24). With the numerous benches used in an open pit operation, the mine area will be opened for some time until the equipment comes back to initiate another pass on a designated bench. As the mining operations remove coal seams (In the southward progression), the mining area must be left open until such time as the lower-most coal seam can be recovered. With the mining configuration, the time differences between mining the upper -most seam versus the lower-most seam will obviously be greater than 180 days. As the operation advances, backfilling will be as contemporaneous as practical but not so as to interfere with removal of the lower-most coal seam. Colowyo will rough backfill and grade as shown on the Spoil Grading Map (Map 29) by methodically and actively dumping and backfilling overburden in the West and East pits very close to final contour so that minimal work will be needed to complete final re -grade of these areas in the future. All disturbed areas will be returned to the approximate original contour by grading and backfilling with the use of a dragline, trucks, dozers, scrapers and dozers assisting a dragline. Additional detail of the backfilling and grading for the mining operation is set forth in the discussion under Sections 2.05.3 and 2.05.4. The area to be mined will be restored to a topography approximating premining grades. The outslopes of the completed fill in Streeter Draw and areas backfilled, as necessary, will utilize terraces and/or contour furrows for erosion control and stability. These terraces and contour furrows will be constructed according to the requirements outlined in Section 2.06.2. Where applicable, Colowyo will retain all overburden and spoil on the solid portion of existing benches. The final graded slopes will not exceed the approximate original premining slope grade as shown on the Postmining Topography Map (Map 19). Postmining surface drainage channels will be located to minimize erosion and to minimize slippage. The final pit highwalls will be eliminated in Section 16 by backfilling X seam overburden materials from the West Pit mining area to achieve the final topography. Rehandle of the X seam overburden will be occur concurrently with the advance of the multiple -seam advance during the 2003-2010 period. Also, as mining advances into the final pit, the working area on the pit spoil side will decrease to a point where insufficient spoil room below the proposed postmining contours is available. When that point is reached, material will be temporarily placed above the proposed postmining topography. When the final pass of the West Pit is mined out, this temporarily -placed spoil will be rehandled concurrently with Section 16 virgin and rehandle material to fill and slope the pit to the configuration shown on Map 19 (Postmining Topography). Because the area will be redisturbed by the rehandle activities, that portion of the north end of Section 16 that is above final grade will not be topsoiled or otherwise reclaimed until final reclamation. Final reclamation of the East Pit will take place via the sequence shown on Map 29 (Spoil Grading — South Area) with the reclamation blocks advancing from east to west or from the topographic bottom to the topographic top of the mining areas. Just as in the West Pit, all disturbed areas will be returned to approximate original contour by grading and backfilling with the use of draglines, Rule 4 Performance Standards 4-43 Revision Date: 5/25/18 Revision No.: RN -07