2018-05-18_HYDROLOGY - P2017008

• Permit No: P2017008
• IBM Index Class Name: HYDROLOGY
• Doc Date: 5/18/2018
• Doc Name Note: FINAL
• Doc Name: Abandonment Report
• From: Brandon Heser
• To: DRMS
• Email Name: TC1
• Media Type: D
• Archive: No

, C O L ® R A D O WELL PERMIT NUMBER 307363-
Division of Water Resources RECEIPT NUMBER 3683171 F
ORIGINAL PERMIT APPLICANT61l APPROVED WELL LOCATION
TRANSIT MIX CONCRETE CO Water Division 2 Water District 10
Designated Basin: N/A
Management District: N/A
County: EL PASO
Parcel Name N/A
AUTHORIZED AGENT Physical Address: 2485 HITCH RANCH ROAD COLORADO
HYDRO-LOGIC SOLUTIONS, INC (DAY,MIKE) SPRINGS, CO 80926
NE 114 SE 1/4 Section 16 Township 16 0 S Range 67.0 W Sixth P,M
UTM COORDINATES (Meters, Zong:13. NAD83)
Easting: 509911.0 Northing: 4278558.0
PERMIT TO CONSTRUCT A NEW WELL
ISSUANCE OF THIS PERMIT DOES NOT CONFER A WATER RIGHT
CONDITIONS OF APPROVAL
11 This well shalt be used in such a way as to cause no material m)ury to existing water rights. The issuance of this permit does
not ensure that no injury will occur to another vested water right or preclude another owner of a vested water right from
seeking relief in a civil court action.
2) The construction of this well shall be in compliance with the Water Well Construction Rules 2 CCR 402-2, unless approval of a
variance has been granted by the State Board of Examiners of Water Well Construction and Pump Installation Contractors in
accordance with Rule 18.
13) Approved pursuant to CRS 37-92-602(3)(b)(I) for uses as described in CRS 37-92-602(1)(f). Use of this welt is limited to
monitoring water levels and/or water quality sampling.
i4) Approved for the use of an existing well acknowledged for construction under monitoring hole notice 56847-MH, and known as
LTC-GW-6.
5) This well must be equipped with a locking cap or seal to prevent welt contamination or possible hazards as an open well, The
well must be kept capped and locked at all times except during sampling or measuring.
6) Records of water level measurements and water quality analyses shall be maintained by the well owner and submitted to the
Division of Water Resources upon request.
7) Upon conclusion of the monitoring program the wet[owner shall plug this well in accordance with Rule 16 of the Water Well
Construction Rules. A Well Abandonment Report must be completed and submitted to the Division of Water Resources within 60
days of plugging,
8) The owner shall mark the well in a conspicuous location with the welt permit number and name of aquifer as appropriate, and
shall take necessary means and precautions to preserve these markings.
9) This welt must have been constructed by or under the supervision of a licensed welt driller or other authorized individual
according to the Water Well Construction Rules.
I10) This well must be located not more than 200 feet from the location specified on this permit.
NOTE: Issuance of this permit does not guarantee that this well can be converted to a production welt under a future permit.
Additionally, pursuant to Rule 14.2 of the Water Welt Construction Rules(2 CCR 402.2), monitoring holes constructed pursuant
to a monitoring hole notice shall not be converted to a production well. (Upon obtaining a permit from the State Engineer, a
monitoring hole may be converted to a monitoring well, recovery well for remediation of the aquifer, or a dewatering system
for dewatering the aquifer.)
NOTICE: This permit has been approved subject to the following changes: The quarter/quarter and quarter were determined
from UTM coordinate values provided with the permit application. You are hereby notified that you have the right to appeal
the issuance of this permit, by filing a written request with this office within sixty(60)days of the date of issuance, pursuant to
the State Administrative Procedures Act. (See Section 24-4.104 through 106, C.R.S.)
Printed 10-25-2017 For questions about this permit call 303.866.3581 or go to www.water.state.co.us Page 1 of 2