Laserfiche WebLink
To. DRMS Den Page 6 of 10 2016-08-31 16-105.58(GMT) 13032008630 From Greg Lewicki <br /> ANIONIC EMULSION FLOCCULANT <br /> DESCRIPTION PREPARATION S FEEDING <br /> HYPERFLOCP AE 852 is a medium charge, Solutions of HYPERFLOCP AE 852 are <br /> very high molecular weight anionic prepared by adding the neat polymer to water <br /> polyacrylamide flocculant supplied as a low below 120*F(50°C)either through an automatic <br /> viscosity emulsion. It is effective over the pH polymer feed unit or into the vortex of a stirred <br /> range of 5-12. tank of water to prepare a solution of 1% <br /> concentration(as is). Aging for 30-60 minutes <br /> TYPICAL PROPERTIES is recommended,followed by in-line dilution to <br /> Appearance Opaque Liquid 0.1%or less. Avoid excessive mixing as this <br /> Specific Gravity at 25°C 1.04 t 0.02 can lead to polymer degradation. Use of gear <br /> Viscosity as supplied at 25°C 500-1500 cps or positive displacement pumps is <br /> Viscosity*(1%Solution) 1000-1400 cps recommended. <br /> pH of 1.0%Solution at 25'C 7.0 t 1.0 <br /> Freeze Point 5°F(A6-0) STORAGE & HANDLING <br /> Flash Point >200°F(93°C) HYPERFLOCP AE 852 should be stored in a <br /> Shelf Life 6 Months heated building, 5°-35°C(40° -95°F). If <br /> frozen,the product should be allowed to thaw <br /> •esela LVF,30`�`°at 26•C In deianized waterrcompletely and agitated prior to use. Storage in <br /> APPLICATIONS stainless steel, plastic or epoxy lined steel is <br /> HYPERFLOCPAE 852 is used in a broad range recommended. Mild steel, iron,aluminum or <br /> of solid-liquid separation processes in water copper are to be avoided in both storage and <br /> and waste treatment and mineral processing feed equipment. Bulk material should be mixed <br /> applications for settling, thickening and every 1 -2 days using a low shear recirculating <br /> dewatering. It can be used alone or in pump, bottom to top. Mixers can be used In <br /> conjunction with alum or ferric salts, drums or liqui-bins if necessary. Spills should <br /> polyaluminum chloride, polyamines and be wiped up with an absorbent material and <br /> polyDADMACs. then washed down with a bleach solution. <br /> Depending on the application,the following Toxicity is low, but normal precautionary <br /> dosage levels are recommended: clothing should be wom when handling this <br /> material. For additional Information, see <br /> Water&Waste Treatment: relevant Material Safety Data Sheet, <br /> Settling/Clarification 0.5 to 20 ppm <br /> Thickening/Dewatering 1.0 to 20 lbs/ton SHIPPING <br /> HYPERFLOCP AE 852 is shipped in 55 gallon <br /> Minerals Processing: non-retumable steel drums at 450 pounds net, <br /> Settling/Thickening 0.01 to 0.2 lbsiton in non-retumable liqui-bins at 2300 pounds net; <br /> Dewatering 0.1 to 2 IbsAon or in bulk. <br /> 03/02 <br /> Charlie Schulte <br /> Tons Per Hour <br />