2015-12-09_PERMIT FILE - M2015030

Home Browse Search

111111111111 111111 111111111111111111111 III 1111111111111 3591169 11/21/2008 02:18P Weld County, CO KerrAtGee 21 of 22 R 111.00 0 0.00 Steve Moreno Clerk & Recorder General Guidelines for Design and Construction Activities On or Near Kerr- McGee Gathering LLC and Kerr - McGee Oil & Gas Onshore LP Pipelines and Related Facilities • Heavy equipment will not be allowed to operate directly over KMG pipelines or in KMG ROW unless written approval is obtained from KMG. Heavy equipment shall only be allowed to cross KMG pipelines at locations designated by KMG. Haul roads will be constructed at all crossings. The haul roads will be constructed using lightweight equipment. The existing depth of cover over the pipeline must be verified. Cover will be added such that a total of 8' of fill exists over the pipeline and extends a minimum of 10' on each side of the pipeline. Depth of cover will then taper as required for equipment access. Steel plates may be used for load dissipation only if approved in writing by KMG. • Contractor shall comply with all precautionary measures required by KMG,at it's sole discretion to protect Its pipelines. When inclement weather exists, provisions must be made to compensate for soil displacement due to subsidence of tires. • Excavating or grading which might result in erosion or which could render the KMG ROW inaccessible shall not be permitted unless the contractor agrees to restore the area to its original condition and provide protection to KMG's facility. At no time will cover be reduced to less than 36" without written approval by KMG and a KMG representative on site. • A KMG representative shall be on-site to monitor any construction activities within twenty-five (25) feet of a KMG pipeline or aboveground appurtenance. The contractor shall not work within this distance without a KMG representative being on site. Contractor shall use extreme caution and take any appropriate measures to protect KMG facilities. + Ripping is only allowed when the position of the pipe is known and not within ten (10) feet of KMG facility. KMG personnel must be present. Temporary support of any exposed KMG pipeline by Contractor may be necessary if required by KMG's on-site representative. Backfill below the exposed lines and 12° above the lines shall be replaced with sand or other selected material as approved by KMG's on-site representative and thoroughly compacted in 12" lifts to 95% of standard proctor dry density minimum or as approved by KMG.'s on-site representative. This is to adequately protect against stresses that may be caused by the settling of the pipeline. • No blasting shall be allowed within '1000 feet of KMG's facilities unless blasting notification is given to KMG Including complete Blasting Plan Data. A pre -blast meeting shall be conducted by the organization responsible for blasting. KMG shall be indemnified and held harmless from any loss, cost of liability for personal injuries received, death caused or property damage suffered or sustained by any person resulting from any blasting operations undertaken within 500 feet of its facilities. The organization responsible for blasting shall be liable for any and all damages caused to KMG's facilities as a result of their activities whether or not KMG representatives are present. KMG shall have a signed and executed Blasting indemnification Agreement before authorized permission to blast can be given. No blasting shall be allowed within 200 feet of KMG's facilities unless blasting notification is given to KMG a minimum of one week before blasting. The organization responsible for blasting must complete Blasting Plan Data. KMG shall review. and analyze the blasting methods. A written blasting pian shall be provided by the organization responsible for blasting and agreed to in writing by KMG. A written emergency plan shall be provided by the organization responsible for blasting. KMG shall have a signed and executed Blasting indemnification Agreement before authorized permission to blast can be given. A pre -blast meeting shall be conducted by the organization responsible for blasting. • Any contact with any KMG facility, pipeline, valve set, etc. shall be reported immediately to KMG. If repairs to the pipe are necessary, they will be made and inspected before the section is re -coated and the line is back-filled. KMG personnel shall install all test leads on KMG facilities. Local Kerr-McGee Gathering LLC Representation: Manager of Construction & Facilities Engineering: Kevin R. Osif, P.E. Facilities Engineer. Joseph E. Sanchez, P.E. Foreman 1: James Phillips Foreman 1: Rick Noffsinger Phone: 303 655 - 4307 Phone: 303 655 - 4319 Phone: 303 855 - 4343 Phone: 303-655 - 4326 Page 3 of 4 Revision 3/01/2004