Laserfiche WebLink
Exhibit A — Legal Description <br />6.4.1 EXHIBIT A - Legal Description <br />1) The legal description must identify the affected land, specify affected areas and be <br />adequate to field locate the property. Description shall be by (a), township, range, and <br />section, to at least the nearest quarter -quarter section and (b), location of the main <br />entrance to the site reported as latitude and longitude, or the Universal Transverse <br />Mercator (UTM) Grid as determined from a USGS topographic map. A metes and <br />bounds survey description is acceptable in lieu of township, range, and section. Where <br />available, the street address or lot number(s) shall be given. This information may be <br />available from the County Assessor's office or U.S. Geological Survey (USGS) maps. <br />The property boundary comprises 156.78± acres. As located near its center at <br />approximately the Southeast Corner of the NW/4NW/4; Sec. 33; T3N; R67W; 6th <br />P.M.; Weld County, Colorado the permit boundary more specifically covers the <br />near full quarter section of the NW/4; Sec. 33; T3N; R67W; 6th P.M.; Weld <br />County, Colorado; and more fully by quarter -quarter section description includes <br />the NW/4NW/4 and the NE/4NW/4 and the SE/4NW/4 and the SW/4NW/4 of <br />Section 33; Township 3 North; Range 67 West; 6th P.M.; Weld County, Colorado. <br />The legal description for the property boundary and permit area is further detailed <br />on the included maps, including Exhibit C-1: Existing Conditions Map; and <br />Exhibit C-2: Extraction Plan Map; in conformance with Rule 6.4. All lands within <br />the designated Permit Boundary are to be considered Affected Lands. The <br />Extraction Limits designating the maximum reach of extraction, which may be less <br />but not more than the Extraction Limits shown on Exhibit C-1: Existing Conditions <br />Map; and Exhibit C-2: Extraction Plan Map. Existing residential property is <br />excluded from the permit boundary, as shown. Additional information on Affected <br />Lands may be found under Exhibit D — Extraction Plan and Exhibit E — <br />Reclamation Plan. <br />2) The main entrance to the mine site shall be located based on a USGS topographic <br />map showing latitude and longitude or Universal Transverse Mercator (UTM). The <br />operator will need to specify coordinates of latitude and longitude in degrees, minutes <br />and seconds or in decimal degrees to an accuracy of at least five (5) decimal places <br />e.g., latitude 37.12345 N, longitude 104.45678 W). For UTM, the operator will need to <br />specify North American Datum (NAD) 1927, NAD 1983, or WGS 84, and the applicable <br />zone, measured in meters. <br />The main entrance is identified as `Proposed Access': (latitude 40.18956 North, <br />104.89517 East) as shown near the Northeast corner of the permit/property <br />boundary. <br />Varra Companies, Inc. OMLR 112 Permit Application I <br />Parcel 122 — Resource Development Project 1 July 2015 — Revised 25 August 2015