2014-10-27_REVISION - M1990057 - Laserfiche WebLink

Home Browse Search

Form No. OFFICE OF THE STATE ENGINEER GWS-25 COLORADO DIVISION OF WATER RESOURCES 818 Centennial Bldg, 1313 Sherman St..Denver,Colorado 80203 (303)866-3581 LIC WELL PERMIT NUMBER 295655 - APPLICANT DIV. 2 WD 11 DES. BASIN MD APPROVED WELL LOCATION LAKE COUNTY NW 1/4 NE 114 Section 33 UNION MILLING COMPANY LLC Township 9 S Range 80 W Sixth P.M. PO BOX 620490 DISTANCES FROM SECTION LINES LITTLETON, CO 80162- 379 Ft. from North Section Line 1333 Ft. from East Section Line (303) 947-7837 UTM COORDINATES (Meters,Zone:13,NAD83) PERMIT TO CONSTRUCT A WELL Easting: 384988 Northing: 4343027 ISSUANCE OF THIS PERMIT DOES NOT CONFER A WATER RIGHT CONDITIONS OF APPROVAL 1) This well shall be used in such a way as to cause no material injury to existing water rights. The issuance of this permit does not ensure that no injury will occur to another vested water right or preclude another owner of a vested water right from seeking relief in a civil court action 2) The construction of this well shall be in compliance with the Water Well Construction Rules 2 CCR 402-2, unless approval of a variance has been granted by the State Board of Examiners of Water Well Construction and Pump Installation Contractors in accordance with Rule 18 3) Approved pursuant to CRS 37-92-602(3)(b)(1)for uses as described in CRS 37-92-602(1)(f). Use of this well is limited to monitoring water levels and/or water quality sampling. 4) This well must be equipped with a locking cap or seal to prevent well contamination or possible hazards as an open well. The well must be kept capped and locked at all times except during sampling or measuring. 5) Records of water level measurements and water quality analyses shall be maintained by the well owner and submitted to the Division of Water Resources upon request 6) Upon conclusion of the monitoring program the well owner shall plug this well in accordance with Rule 16 of the Water Well Construction Rules A Well Abandonment Report must be completed and submitted to the Division of Water Resources within 60 days of plugging 7) The owner shall mark the well in a conspicuous place with the well permit number and name of aquifer as appropriate,and shall take necessary means and precautions to preserve these markings. 8) This well must be constructed by or under the supervision of a licensed well driller or other authorized individual according to the Water Well Construction Rules. If non-standard construction is anticipated,a variance request must be submitted in accordance with Rule 18 and approved prior to well construction 9) A Well Construction and Test Report(Form GWS-31),including lithologic log must be submitted by the individual authorized to construct the well. For non-standard construction,the report must include an as-built drawing showing details such as depth,casing,perforated zones,and a description of the grouting type and interval. 10) This well shall be constructed not more than 200 feet from the location specified on this permit NOTE Issuance of this permit does not guarantee that this well can be converted to a production well under a future permit Additionally, pursuant to Rule 14.2 of the Water Well Construction Rules(2 CCR 402-2),monitoring holes constructed pursuant to a monitoring hole notice shall not be converted to a production well. (Upon obtaining a permit from the State Engineer,a monitoring hole may be converted to a monitoring well,recovery well for remediation of the aquifer,or a dewatering system for dewatering the aquifer.) NOTE This permit will expire on the expiration date unless the well is constructed by that date.A Well Construction and Test Report (GWS-31)must be submitted to the Division of Water Resources to verify the well has been constructed.An extension of the expiration date may be available.Contact the DWR for additional information or refer to the extension request form(GWS-64)available at http://www water.state.co.us NOTICE This permit has been approved subject to the following changes-The distances from section lines,quarter/quarter,and quarter were determined from GPS coordinates provided by the applicant The distances from section lines,quarter/quarter,quarter,Section,Township. Range and P M were determined from UTM coordinate values provided with the permit application You are hereby notified that you have the right to appeal the issuance of this permit,by filing a written request with this office within sixty(60)days of the date of issuance.pursuant to the State Administrative Procedures Act (See Section 24-4-104 through 106,C.R S) APPROVED CRF State Engineer ,Receipt No. 3666028E DATE ISSUED 09-11-2014 EXPIRATI DATE 09-11-2016