Laserfiche WebLink
Material Safety Data Sheet <br />Material Name: Aluminum Sulfate <br />Distributed by: Rocky Mountain Reagents, Inc <br />Part Number: A1055 ID: C1 -166 <br />* * * Section 15 - Regulatory Information <br />US Federal Regulations <br />A: General Product Information <br />Aluminum Sulfate is designated as a hazardous substance under section 311(b)(2)(A) of the Federal Water Pollution Control Act <br />and further regulated by the Clean Water Act Amendments of 1977 and 1978. These regulations apply to discharges of this <br />substance. <br />B: Component Analysis <br />This material contains one or more of the following chemicals required to be identified under SARA Section 302 (40 CFR 355 <br />Appendix A), SARA Section 313 (40 CFR 372.65) and /or CERCLA (40 CFR 302.4): <br />Aluminum Sulfate (10043 -01 -3) <br />SARA 302 (EHS TPQ) There are no specific Threshold Planning Quantities for Aluminum Sulfate. The default Federal <br />MSDS submission and inventory requirement filing threshold of 10,0001bs. (4,540 kg) therefore <br />applies, per 40 CFR 370.20. <br />CERCLA: Final RQ = 5000 pounds (2270 kg) <br />C: Sara 311/312 Tier II Hazard Ratines: <br />Component <br />CAS # <br />Fire <br />Hazard <br />Reactivity <br />Hazard <br />Pressure <br />Hazard <br />Immediate <br />Health Hazard <br />Chronic <br />Health Hazard <br />Aluminum Sulfate <br />10043 -01 -3 <br />No <br />No <br />No <br />Yes <br />Yes <br />State Regulations <br />A: General Product Information <br />Other state regulations may apply. <br />B: Component Analysis - State <br />The following components appear on one or more of the following state hazardous substances lists: <br />Component <br />I CAS # <br />CA <br />FL <br />MA <br />MN <br />NJ <br />PA <br />Aluminum Sulfate (* related to Aluminum) ( ** related to <br />Aluminum, soluble salts <br />10043 -01 -3 <br />Yes <br />Yes* <br />Yes <br />Yes ** <br />Yes <br />Yes <br />Other Regulations <br />A: General Product Information <br />Not determined. <br />B: Component Analysis - Inventor <br />Component <br />JCAS# <br />TSCA <br />I DSL <br />EINECS <br />Aluminum Sulfate <br />10043 -01 -3 <br />Yes <br />I Yes <br />Yes <br />C: Component Analysis - WHMIS IDL <br />The following components are identified under the Canadian Hazardous Products Act Ingredient Disclosure List: <br />Com onent <br />CAS # <br />Minimum Concentration <br />Aluminum Sulfate <br />10043 -01 -3 <br />1% item 53 198 related to Aluminum, soluble salts <br />ANSI Labeline (Z129.1): <br />CAUTION! MAY CAUSE RESPIRATORY SYSTEM, SKIN AND EYE IRRITATION OR BURNS. HARMFUL IF INGESTED <br />OR INHALED. Avoid contact with skin, eyes, or clothing. Do not taste or swallow. Avoid breathing dusts and particulates. Use <br />only with adequate ventilation. Wash thoroughly after handling. Wear gloves, goggles, faceshields, suitable body protection, and <br />NIOSH- approved respiratory protection, as appropriate. FIRST -AID: In case of contact, immediately flush skin or eyes with plenty <br />of water for at least 15 minutes while removing contaminated clothing and shoes. If inhaled, remove to fresh air. If ingested, do not <br />induce vomiting. Get medical attention. IN CASE OF FIRE: Use water fog, dry chemical, COZ, or "alcohol' foam. IN CASE OF <br />SPILL: Absorb spill with inert material. Sweep -up, avoiding generation of dusts. Place residue in suitable container. Consult <br />Material Safety Data Sheet for additional information. <br />Issue Date: 4/27/99 08:45:30 CLW Page 7 of 8 Revision Date: 01/04/08 12:30 pm HDF <br />