2011-08-26_REPORT - M1980244 ‎(26)‎

• Permit No: M1980244
• IBM Index Class Name: REPORT
• Doc Date: 8/26/2011
• Doc Name: Final Report QA 2011 Phase 5 VLF Ore Storage Aug 26, 2011 vol 3 of 3 DOCUMENT 1 of 2
• From: CC&V
• To: DRMS
• Media Type: D
• Archive: No

TM
11. Certification that extrudate to be used is composed of the same resin as the geomembrane to
be used.
C. Submittals By CONTRACTOR to MANAGER during the course of the work.
Daily reports detailing arrival and departure times, the personnel present on -site, the
progress of the Work, the arrival of materials, daily square footage deployed and seamed,
daily square footage of geomembrane approved by the CQA Monitor and any problems
encountered.
2. Subgrade surface acceptance certificates for each area to be covered by the lining system,
signed by CONTRACTOR.
D. Without limiting the provisions of the Contract, the CONTRACTOR shall warrant the Work to
MANAGER in accordance with the following:
1. The geomembrane supplied is suitable for the environmental conditions at the site and the
service conditions as described in this SPECIFICATION.
2. The geomembrane supplied meets or exceeds all published SPECIFICATIONS as
referenced by the SPECIFICATION.
3. The geomembrane are free of defects in materials and workmanship.
4. The CONTRACTOR shall repair or replace all defects in the material detected on -site,
including uncovering and recovering the work, in compliance with the SPECIFICATIONS
at no additional cost to CC &V.
5. The CONTRACTOR shall repair any detected leaks in any seams (Manufactured or field
joined), including uncovering and recovering the work, in compliance with the
SPECIFICATIONS at no additional cost to CC &V.
1.03 QUALITY ASSURANCE
A. Manufacturing Qualifications
The MANUFACTURER(s) shall have experience in the manufacture of the type of
geomembrane that is being installed at the Cresson Project totaling at least five completed
facilities totaling a minimum of 5,000,000 square feet between all five facilities.
2. The MANUFACTURER shall provide sufficient production and qualified personnel to meet
the demands of the work and shall have an internal quality control program for its product.
3. The MANUFACTURER shall permit MANAGER, DESIGN ENGINEER, and/or
CERTIFYING ENGINEER or their authorized representative to visit the manufacturing
plant.
B. Geomembrane Installation Qualifications (INSTALLER)
INSTALLER shall be the MANUFACTURER or an approved CONTRACTOR trained
and licensed to install the MANUFACTURER's geomembrane.
Section 02776 Page 3 of 22 September 3, 2008
Geomembrane Revision 1
C: AMEC_CC &V\Phase 5 VLFPSSA Cert Report\Appendices\Appendix E \SPECS \02776A.doc