Laserfiche WebLink
TSTool Documentation Getting Started <br /> Getting Started - 27 <br />The following table lists the TSTool command li ne parameters. <br /> <br />TSTool Command Line Parameters <br /> <br />Parameter Description Default <br />-commands <br />CommandFile <br />Specify the name of the command file to <br />run in batch mode. TSTool will process <br />the commands and exit. <br />Start TSTool in interactive <br />mode. <br />CommandFile The command file can be specified <br />without –commands to start up the <br />TSTool GUI and load the command file. <br />This behavior occurs when selecting a <br />*.TSTool file in Windows Explorer. <br />See also -runcommandsonload . <br /> <br />-config ConfigFile Start TSTool using the specif ied <br />configuration file. This is useful in <br />software test environments. <br />Start TSTool using the <br />system/TSTool.cfg file <br />under the software <br />installation. <br />-dTerm,Log Specify the debug level (0+) for terminal <br />and log file debug messages. This is <br />useful for pri nting troubleshooting <br />messages at startup. One or both values <br />can be specified. <br />No debug messages are <br />generated. <br />-home <br />InstallFolder <br />Specify the install folder. This parameter <br />is used internally by the TSTool launcher <br />(Launch4J) and in the software <br />deve lopment environment to specify the <br />TSTool home, in order to locate other <br />files. <br />Should always be set by the <br />TSTool launcher. <br />-nodiscovery Do not run discovery on commands as <br />they are loaded. This can be used for <br />large command files that will not be <br />edite d, in order to de crease load time. <br />Run discovery on <br />commands as they are <br />loaded. <br />-nomaingui Do not show the TSTool main GUI when <br />running commands, but do allow graph <br />windows to be displayed. Closing the last <br />visible graph window will close the <br />TSTool app lication. <br />If –commands is <br />specified, do not show any <br />windows. If <br />-nomaingui also is <br />specified, allow graph <br />windows to show. <br />-runcommandsonload Load and run the commands, used to start <br />the GUI with a specific command file. <br /> <br />-server Start TSTool as a REST restlet server <br />(under development). <br /> <br />-test Run TSTool in test mode, for developers. <br />Property=Value Define TSTool global properties (similar <br />to the configuration file). These <br />properties typically are used during <br />development to test specific features. <br /> <br /> <br /> <br />53