Laserfiche WebLink
Release Notes <br />TSTool Documentation <br />• Increase performance at startup when no main GUI is shown, for cases when TSTool is being used to <br />provide graphs for other software. <br />• Add support for Universal Naming Convention (UNC) for software home in startup files. <br />• Change View ...Map Interface to View ...Map. <br />Changes in Version 6.16.00 <br />• Implement hooks for the NDFD input type. <br />• Improve handling ofNWS Card file extensions in commands and File ... Save menu choices. <br />• Add map interaction features. See the Installation and Configuration Appendix for more <br />information about configuring links with maps. <br />Changes in Version 6.15.00 <br />• Begin implementing link between time series and map interface. <br />• Reorder general command menus to be more consistent with other software. <br />• Add warning if time series cannot be retrieved from the RiversideDB input type. <br />Changes in Version 6.14.00 <br />• Change the setQueryPeriod () command to setlnputPeriod () to be consistent with other <br />software nomenclature. The old command is still supported. <br />• The readNwsCard O and TS Al ias = readNwsCard O commands both now use the named - <br />parameter notation and have the new Pead24HourAsDay parameter. <br />• Blank lines in commands files now display properly. <br />• Fix bug where time series table sometimes showed half -drawn rows. <br />• Fix bugs where StateMod binary and StateCU input type file chooser prompt would not allow a <br />cancel of the file select to occur. Cancel now results in the previous file that was selected being <br />displayed. <br />Changes in Version 6.12.00 <br />Improve error handling for processing time series products. In particular, TSTool now returns a non- <br />zero exit status if there is an error processing a product. This can be detected by external software <br />that is running TSTool. <br />Changes in Version 6.11.00 <br />• Enable the ColoradoSMS input type and begin adding alert annotations for streamflow graphs. <br />• Fix bug so that if a commands file is specified using a relative path, the working directory is <br />interpreted correctly to determine the full path to the commands file. <br />• Add the ability to accept Parameter =value command line parameters. This will allow override <br />of configuration file information. <br />• Convert processTSProduct O to use named parameters and ensure that output can be viewed <br />even if in batch mode with no main GUI. <br />• Update so that for batch runs, the CDSS cfg file information for HydroBase is used to make the initial <br />connection. Phase out the HydroBase database properties in the TSTool. cfg file. <br />Changes in Version 6.10.09 <br />■ Convert cumulate () to use named parameters and begin development of a new Reset parameter. <br />22 - Appendix — Release Notes <br />