Laserfiche WebLink
<br />Appendix A-3 <br /> <br /> <br />IDAM(K) <br /> <br />(5) IDAM(K) - 8 I 10 Format <br /> <br />Number of cross section coincident with the upstream <br />face of each dam; K index goes from 1 to MULDAM. <br />This parameter is only read-in when the <br />simultaneous computation of the complete system is <br />desired (see note on page A-23 for further <br />information on the use of this computational <br />option), The option to create cross sections <br />within the most upstream reservoir from surface <br />area (SA) - elevation (HSA) table is activated by <br />specifying IDA~(l) as a negative number whose <br />absolute value also represents the total number of <br />cross sections to be automatically created within <br />the upstream reservoir. <br /> <br />Note: <br /> <br />Cards (6) and (7) are omitted if KUI~l except as described in Note on <br />page A-24 concerning Level- Pool Routing for options 11 & 12. <br /> <br />( 6) <br /> <br />SA(K) <br /> <br />SA(K) - 8 F 10,0 Format <br /> <br />Surface area (acres) or volume (acre-ft) of reservoir <br />at elevation HSA(K). Maximum of 8 values <br />allowed. Area or volume determined by VOL <br />parameter (card (8)), Surface area is preferred <br />since reservoir storage (level-pool) routing uses <br />area, and the volume to area conversion algorithm <br />does not always provide a good transformation. <br /> <br />HSA(K) <br /> <br />(7) HSA(K) - 8 F 10.0 Format <br /> <br />Elevation (ft) at which reservoir surface area SA(K) <br />is defined; elevation is referenced to a datum <br />plane corresponding to mean sea level (m.s,l.). <br />Elevations start at highest and proceed to <br />lowest. Maximum of 8 values allowed. Lowest <br />elevation must be < YBMIN as defined on card (8). <br /> <br />Note: <br /> <br />Cards (8) and (9) are omitted if KKN = 9. <br /> <br />(8) <br /> <br />RLM <br /> <br />RLM, YO, Z, YBMIN, BB, TFH, DATUM, VOL - 8 F 10.0 Format <br /> <br />Length (mi) of reservoir; only used when option to <br />create reservoir,cross sections is used (see card <br />(5)) . <br /> <br />,"ii. <br />t,,: <br />"'1" <br />, '." <br /> <br />i <br /> <br />,'0 <br />" <br /> <br />"m' , <br />"I: <br />, l...'.. <br />;~i <br />.!tf.. <br />,-t1~~-~ <br />