FLOOD05059

• County: Statewide
• Community: Nationwide
• Basin: Statewide
• Title: WSP2 Computer Program
• Date: 5/1/1976
• Prepared By: USDA Soil Conservation Service - Engineering Division
• Floodplain - Doc Type: Educational/Technical/Reference Information

SCS-ENG-16
REV. DEC.1974

WSP2

TITLE

DISCHARGE

STARTS

STARTE

TRIB

OUTPUT

COMMENT

DELTA ELEV

BASIC
DRAINAGE AREA

CSM

XSEC NAME

ELEVATION

OUTPUT OPTIONS

OR .

RESETS ALL PROGRAM VARIABLES TO PROGRAM DEFINED VALUES FOR
BEGINNING OF A NEW JOB. THIS MUST BE THE FIRST CARD OF A
JOB.

11-20 MAXIMUM ELEVATION DIFFERENCE BETWEEN X-SECTION COORDINATES
WITHOUT A CAUTION STATEMENT RESULTING IN PRINTOUT. DEFAULT
IS 20 FEET.

11-70 ANY ALPHAMERIC DATA. THE FIRST TITLE ENTERED WILL BE
RETAINED FOR THE ENTIRE JOB, AND WILL BE PRINTED AT THE TOP
OF EACH PAGE. IT MAY NOT BE ALTERED. THE SECOND TITLE
ENTERED WILL ALSO BE PRINTED AT THE OF EACH PAGE. IT
MAY BE ALTERED AT ANY TIME.

11-20

21-30
31-40
41-50
51-60
61-70

ENTERS BASIC CSM VALUES TO BE USED.

THE DRAINAGE AREA AT THE LOWER END OF THE WATERSHED.
(SEE NOTE).

THE CSM VALUES FOR EACH tROFILE DESIRED. THESE VALUES SET
THE ORDER OF COMPUTATIONS. I.E. THE FIRST CSM VALUE ENTERED
IS THE FIRST PROFILE RUN. UP TO 3 CARDS MAY BE USED.

SAME AS STARTE EXCEPT THAT SLOPES IN FT/FT ARE ENTERED INSTEAD
OF ELEVATIONS.

USED TO ENTER THE STARTING ELEVATIONS FOR EACH PROFILE TO BE
RUN. UP TO 3 CARDS PER SECTION MAY BE USED BUT ONLY ONE
SECTION MAY BE ENTERED AT ONE TIME.

11-20 THE NAME OF THE CROSS SECTION FOR WHICH THE STARTING ELEVATIONS
APPLY. THE NAME MUST BE ENTERED IN EACH CARD USED.

21-70
BY 10
COL.
FIELDS

11-70
BY 10
COL.
FIELDS

THE STARTING ELEVATION FOR EACH CSM.
ENTERED REFERS TO THE FIRST CSM ETC.

THE FIRST ELEVATION

THE NAMES OF CROSS SECTIONS WHERE DATA ARE TO BE HELD FOR USE
AS STARTING DATA ON LATER PROFILES. THESE NAMES CANNOT BE
ROAD NAMES. UP TO 20 NAMES MAY BE USED.

THIS CARD SETS THE OUTPUT SWITCHES FOR THE TYPE OF OUTPUT
DESIRED. EACH TIME AN OUTPUT CARD IS ENTERED ALL PREVIOUS
OUTPUT OPTIONS ARE TURNED OFF. THE PRINTED VALLEY SECTION
AND BRIDGE RATING TABLES ARE STANDARD OUTPUT.

11-20 R - PUNCH RATING TABLE FOR INPUT TO HYDROLOGY PROGRAM.
P - PLOT RATING TABLES
S - PRINT SEGMENT TABLE
K - KD TABLE

NOTE THESE OPTIONS MAY BE ENTERED IN ANY ORDER.

PROVIDES AN 80-80 LIST OF DESIRED COMMENTS ON THE OUTPUT
LISTING OF INPUT DATA. DO NOT USE WITHIN GROUPS OF CARDS
THAT GO TOGETHER SUCH AS SEGMENT AND NVALUE.

11-70 THE DESIRED TEXT.

NOTE: AN OPTION HAS BEEN ADDED SO THAT A GIVEN PROFILE IN
CFS CAN BE RUN. TO 00 THIS INPUT A NEGATIVE VALUE FOR BASIC
DRAINAGE AREA. ENTER THE CFS VALUE FOR EACH REACH IN PLACE
OF THE DRAINAGE AREA ON THE REACH CARD. THEN PUT A VALUE OF
1.0 FOR THE FIRST CSM VALUE. IF PROFILES WITH CFS VALUES
RATIOED UP OR OOWN FROM THE GIVEN VALUES AT EACH SECTION ARE
DESIRED, THESE RATIOS CAN BE LISTED IN PLACE OF CSM VALUES.

NOTE: NAMES MAY CONSIST OF FROM 1 to 6 ALPHA NUMERIC CHARAC-
TERS. IMBEDDED BLANKS ARE IGNORED SO A - SHOULD BE USED TO
SEP~E CHARACTERS IF DESIRED. THE NAME MAY BE AN\'1fflERE
WITHIN THE NAME FIELD.

20