TSTool

• Title: TSTool
• Decision Support - Doc Type: Software Documentation
• Date: 10/5/2004
• DSS: Colorado River
• Basin: Colorado Mainstem
• Contract/PO #: C153658, C153727, C153752
• Bill Number: SB92-87, HB93-1273, SB94-029, HB95-1155, SB96-153, HB97-008
• Prepared By: Riverside Technology inc.

Commands
TSTooI Documentation
4.7 Output Time Series
The Commands...0utput Time Series menu inserts commands for outputting time series.
wrikeDakeValue(),,, ~wrike DakeValue file
wrikeNwsCard(),,, ~v~rike NVJS Card file
wrikeNVJSRFSESPTra~eEnsemble(),,, ~wrike ESP kra~e ensemble file
wrikeRiverVJare~),, , ~v~rike Riverare file
wrikeSkakeCU(),,, ~wrike SkakeCU File
wrikeSkakeMad(),., ~wrike SkakeMad file
wrikeSummary~),,, ~wrike Summary File
pra~essTSPradu~k(),,, ~pra~ess a kime series pradu~k File
desele~kTimeSeries(),,, ~desele~k kime series far aukpuk~
seleckTimeSeries(),,, ~seleck kime series far aukpuk~
sekOukpukPeriad(),,, afar aukpuk pradu~ks~
Commands...0utput Time Series Menu
OutputTimeSeries
Commands that operate on time series are listed first and commands that set global configuration values
(e.g., output period) are listed at the end of the menu.
Using the output commands allows the results of processing to be saved but increases processing time. If
commands are processed repeatedly during analysis or debugging, the following steps may be taken to
increase overall efficiency:
Output commands are not executed if the Commands list is processed with Run... All
Commands (ignore output commands) or Run...Selected Commands (ignore output
commands). Therefore, use this menu choice to ignore the output commands.
Only selected commands are processed. Therefore select all but the output commands.
Use an exit control command before output commands to skip the output commands. This
command can then be deleted or commented out when not needed.
Commands can be converted to comments using the Commands menu or the popup menu that is
displayed when right-clicking on the Commands list. Therefore, output commands can be
temporarily converted to comments until output needs to be created.
4.8 Commands for Specific Input Types
Depending on the input types that are enabled, additional command menus may be enabled. For example,
if the HydroBase input type is enabled, a HydroBase menu will be enabled, and will list commands
specific to HydroBase. In particular, commands like openHydroBase O are provided to make
database connections while processing commands.
Commands - 10