WSP11290 - Laserfiche WebLink

Home Browse Search

I- I,.. I,') - _'D1-~" The following exhibits must be attached to each copy of this application. All must be 10 far as possible on sheets 81hxll inches, or must fold to these dimensions. Read care- fully instructions on instruction sheet, Form 202-A. A. LOCATION SHEET. This should be a key map on a scale where one inch'equals approx- imately twenty-five miles. The location of the project should be clearly indicated in red. Photostatic reductions of standard maps, with the location of the project superimposed in red ink, will serve for this purpose. B. LOCATION SHEET. (Detail.) This should show the location more in detail, where one inch equals approximately one mile. If one sheet is not suftlcient, divide into two or more sheets. C. DIMENSION AND DETAIL SHEET. This should be to an appropriate scale which will vary with the size of the project. Use more than one sheet if necessary. Typical cross section, plan and other schematic views of the proposed improvement, with principal gov- erning dimensions should be shown. Avoid too great detail. D. AtlilDITIONAL AND MORE DETAILED STATEMENT AS TO GENERAL NATURE AND PURPOSE. E. DEPARTMENTAL EXHIBITS. Copies of any reports, resolutions, or other action, by any Committee of Congress or any Federal, State or Local Agency made directly on this project and cited in Item (6) above should be furnished. If more than one, mark E, E-l, etc. Size of these exhibits need not conform to 81hxll inches. F. DETAIL OF ESTIMATED ANNUAL ECONOMIC BENEFITS. G. DETAIL OF ESTIMATED ANNUAL REVENUE. H. DETAIL OF OTHER CREDITS TO THE PROJECT. I. DETAIL OF ESTIMATED COST. J. DETAIL OF ESTIMATED ANNUAL OPERATING AND MAINTENANCE EXPENSE. OPTIONAL AND ADDITIONAL EXHIBITS. If these refer to items covered by exhibits A through J. they should be marked with the appropriate letter with sub-number, e. g., A-I, F-l, etc. If not, they should be marked by letters consecutively, beginning with K. Op- tional exhibits not especially prepared for this application need not conform to 81hxll inches where this is impracticable. 17. CERTIFICATION: If it is desired that the project be examined by the Committee as to its eligibility for classification in Division I or Division II, the following certificate must be duly executed. Applicants are advised to have the engineer signing the certificate present for questioning by the Committee at any hearing desired by the applicants. NO PROJECT WILL BE PLACED IN EITHER DIVISION I OR DIVISION II UNTIL THE DATA SUBMITTED IN ITS JUSTIFICATION SHALL HAVE BEEN CERTIFIED AS FOLLOWS: CERTIFICATION State of _______________________m___ Registration No. of Professional ~ t./ < . Engineer signing this certificate_~-::::_____ The undersigned'f-~JI ~~~::~-, a registered Professio~l Engineer in the state of ~__~-3::!_~_~__, hereby certifies that he has carefully studied all tech- nological and economic data, and their sources, presented in this application and in the at- tached exhibits Nos. ________ and that in his opinion, except as specifically noted in his sup- plementary statement attached hereto and marked Exhibit S, they are reasonably derived from adequate information in accordance with accepted principles of economica and engineer- ing. . In witness wher f I have hereunto sign ed my name and set my professional seal this q;;.{ ----.,~&..-.-J1 . 19~::(, in the city of _~~..,"--.e.-J --_ and State of Registered Professional Engineer No. .t'; .3._ SEA L State of &.!4I--..~ The certifying engineer will initial one of the two following boxes: [i(i. No exceptions, and no lupplementary statement attached o 2. Supplementary statement marked Exhibit S, attached hereto. 17 .....17 6-1.a-m-1_